ir3831 International Rectifier Corp., ir3831 Datasheet - Page 4

no-image

ir3831

Manufacturer Part Number
ir3831
Description
Synchronous Buck Regulator For Ddr Applications
Manufacturer
International Rectifier Corp.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ir3831MTR1PBF
Manufacturer:
IR
Quantity:
20 000
Part Number:
ir3831MTRPBF
Manufacturer:
IR
Quantity:
20 000
Company:
Part Number:
ir3831WMTRPBF
Quantity:
9 000
Company:
Part Number:
ir3831WMTRPBF
Quantity:
3 800
Company:
Part Number:
ir3831WMTRPBF
Quantity:
4 000
Pin Description
Pin
10
11
12
13
14
15
02/20/09
1
2
3
4
5
6
7
8
9
SS/SD
PGood
Enable
Name
OCSet
Comp
PGnd
Boot
Gnd
Gnd
V
SW
V
Vp
Fb
Rt
CC
IN
¯¯
Track pin. Use External resistors from VDDQ rail. The Vp voltage can
be set to 0.9V for DDR2 application and 0.75 or 0.6V for DDR3
application.
Inverting input to the error amplifier. This pin is connected directly to the
output of the regulator via resistor divider to set the output voltage and
provide feedback to the error amplifier.
Output of error amplifier. An external resistor and capacitor network is
typically connected from this pin to Fb pin to provide loop
compensation.
Signal ground for internal reference and control circuitry.
Set the switching frequency. Connect an external resistor from this pin
to Gnd to set the switching frequency.
Soft start / shutdown. This pin provides user programmable soft-start
function. Connect an external capacitor from this pin to Gnd to set the
start up time of the output voltage. The converter can be shutdown by
pulling this pin below 0.3V.
Current limit set point. A resistor from this pin to SW pin will set the
current limit threshold.
Power Good status pin. Output is open drain. Connect a pull up resistor
from this pin to Vcc. If unused, it can be left open.
This pin powers the internal IC and drivers. A minimum of 1uF high
frequency capacitor must be connected from this pin to the power
ground (PGnd).
Power Ground. This pin serves as a separated ground for the MOSFET
drivers and should be connected to the system’s power ground plane.
Switch node. This pin is connected to the output inductor.
Input voltage connection pin.
Supply voltage for high side driver. Connect a 0.1uF capacitor from this
pin to SW.
Enable pin to turn on and off the device.
Signal ground for internal reference and control circuitry.
Description
IR3831MPbF
4

Related parts for ir3831