p16f877 Microchip Technology Inc., p16f877 Datasheet - Page 22

• Manufacturer Part Number: p16f877
• Description: 28/40-pin 8-bit Cmos Flash Microcontrollers
• Manufacturer: Microchip Technology Inc.

PIC16F87X
2.2.2.3
The INTCON Register is a readable and writable regis-
ter, which contains various enable and flag bits for the
TMR0 register overflow, RB Port change and External
RB0/INT pin interrupts.
REGISTER 2-3:
DS30292C-page 20
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
INTCON Register
INTCON REGISTER (ADDRESS 0Bh, 8Bh, 10Bh, 18Bh)
bit 7
GIE: Global Interrupt Enable bit
1 = Enables all unmasked interrupts
0 = Disables all interrupts
PEIE: Peripheral Interrupt Enable bit
1 = Enables all unmasked peripheral interrupts
0 = Disables all peripheral interrupts
T0IE: TMR0 Overflow Interrupt Enable bit
1 = Enables the TMR0 interrupt
0 = Disables the TMR0 interrupt
INTE: RB0/INT External Interrupt Enable bit
1 = Enables the RB0/INT external interrupt
0 = Disables the RB0/INT external interrupt
RBIE: RB Port Change Interrupt Enable bit
1 = Enables the RB port change interrupt
0 = Disables the RB port change interrupt
T0IF: TMR0 Overflow Interrupt Flag bit
1 = TMR0 register has overflowed (must be cleared in software)
0 = TMR0 register did not overflow
INTF: RB0/INT External Interrupt Flag bit
1 = The RB0/INT external interrupt occurred (must be cleared in software)
0 = The RB0/INT external interrupt did not occur
RBIF: RB Port Change Interrupt Flag bit
1 = At least one of the RB7:RB4 pins changed state; a mismatch condition will continue to set
0 = None of the RB7:RB4 pins have changed state
Legend:
R = Readable bit
- n = Value at POR
R/W-0
GIE
the bit. Reading PORTB will end the mismatch condition and allow the bit to be cleared
(must be cleared in software).
R/W-0
PEIE
R/W-0
T0IE
W = Writable bit
’1’ = Bit is set
R/W-0
INTE
Note:
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared
R/W-0
RBIE
Interrupt flag bits are set when an interrupt
condition occurs, regardless of the state of
its corresponding enable bit or the global
enable bit, GIE (INTCON<7>). User soft-
ware should ensure the appropriate inter-
rupt flag bits are clear prior to enabling an
interrupt.
R/W-0
T0IF
2001 Microchip Technology Inc.
x = Bit is unknown
R/W-0
INTF
R/W-x
RBIF
bit 0