p-2.5dbqs-cr1-d1 DDK Ltd., p-2.5dbqs-cr1-d1 Datasheet - Page 10

• Manufacturer Part Number: p-2.5dbqs-cr1-d1
• Description: Sma Style Coaxial Connector
• Manufacturer: DDK Ltd.

1
2
3
4
5
6
○ Assembly Insuruction（3）
Level out the end of body
and the end of crimping dies
Sheath
◎ Please acknowledge that the specification etc. of this catalog might change by the improvement etc. without notice.
Moreover, the characteristic and the specification of the published product are the reference values.
Please confirm the content with the latest delivery specifications when you use the product.
http://www.ddknet.co.jp
Cable
g
Crimping Dies
Outer Conductor
A-R1
Center Conductor
Insulator
Ferule
DM Series
L
1
4.5
7.5
11.0
1.0
Ferule
No gap
Insulator
Soldering
Ferule
2.5
Contact
Body
Body
Spread the top
Pre-soldering
Center Conductor
Insulator
Contact
10
（Note）Please be careful to not damage outer
（Note）Please be careful to not deform the insulator
（Note）No gap between contact and insulator.
（Note）When the solder is stick out, please shave
（Note）The boot is required DM-P-1.5DQEW only.
（Note）The gap between connector body and ferule
2. Cut the cable as fig.1.
2-1.Pre-solder the center conductor.
3. Cut the center conductor as fig.3.
4. Solder up the contact to the center conductor of
5 Insert the boot and ferule into the cable.
5-1．Spread the outer conductor and pick equally.
6. Insert the above cable into the connector body
6-1．Covert the ferule on the outer conductor.
6-2．Crimp the ferule. (Crimp Dies：A-R1)
1. The cable length require for the cable assembly
(Note) Please be careful to not deform the insulator
the cable
until strike the top of the cable.
L=L
the extra solder.
by heat.
1
conductor, insulator and center conductor.
by heat.
is within 0.5mm.
-5.7
Body
Unit：mm