ltc3207euf-trpbf Linear Technology Corporation, ltc3207euf-trpbf Datasheet - Page 15

• Manufacturer Part Number: ltc3207euf-trpbf
• Description: 600ma Universal Multi-output Led/cam Driver
• Manufacturer: Linear Technology Corporation

APPLICATIONS INFORMATION
V
The style and value of the capacitors used with the LTC3207/
LTC3207-1 determine several important parameters such
as regulator control loop stability, output ripple, charge
pump strength and minimum start-up time.
To reduce noise and ripple, it is recommended that low
equivalent series resistance (ESR) ceramic capacitors are
used for both C
capacitors are not recommended due to high ESR.
The value of C
ripple for a given load current. Increasing the size of C
will reduce output ripple at the expense of higher start-up
current. The peak-to-peak output ripple of the 1.5x mode
is approximately given by the expression:
Where f
quency, or typically 850kHz, and C
age capacitor.
The output ripple in 2x mode is very small due to the fact
that load current is supplied on both cycles of the clock.
Both style and value of the output capacitor can signifi -
cantly affect the stability of the LTC3207/LTC3207-1. As
shown in the Block Diagram, the device uses a control
loop to adjust the strength of the charge pump to match
BAT
V
, CPO Capacitor Selection
RIPPLEp p
3
f
OSC
OSC
−
•
is the LTC3207/LTC3207-1’s oscillator fre-
C
CPO
CPO
=
VBAT
I
directly controls the amount of output
OUT
and C
CPO
. Tantalum and aluminum
CPO
Figure 4. 10nH Inductor Used for Input Noise Reduction
(Approximately 1cm of Board Trace)
is the output stor-
CPO
the required output current. The error signal of the loop is
stored directly on the output capacitor. The output capacitor
also serves as the dominant pole for the control loop. To
prevent ringing or instability, it is important for the output
capacitor to maintain at least 3.2µF of capacitance over all
conditions and the ESR should be less than 80mΩ.
Multilayer ceramic chip capacitors typically have exception-
al ESR performance. MLCCs combined with a tight board
layout will result in very good stability. As the value of C
controls the amount of output ripple, the value of C
controls the amount of ripple present at the input pin(V
The LTC3207/LTC3207-1’s input current will be relatively
constant while the charge pump is either in the input charg-
ing phase or the output charging phase but will drop to zero
during the clock nonoverlap times. Since the nonoverlap
time is small (~25ns), these missing “notches” will result
in only a small perturbation on the input power supply
line. Note that a higher ESR capacitor such as tantalum
will have higher input noise due to the higher ESR. There-
fore, ceramic capacitors are recommended for low ESR.
Input noise can be further reduced by powering the
LTC3207/LTC3207-1 through a very small series inductor
as shown in Figure 4. A 10nH inductor will reject the fast
current notches, thereby presenting a nearly constant-
current load to the input power supply. For economy, the
10nH inductor can be fabricated on the PC board with
about 1cm (0.4") of PC board trace.
V
GND
BAT
LTC3207-1
LTC3207/
3207 F04
LTC3207/LTC3207-1
15
BAT
VBAT
3207fc
CPO
).