max9706etxt Maxim Integrated Products, Inc., max9706etxt Datasheet - Page 25

• Manufacturer Part Number: max9706etxt
• Description: 3-channel, 2.3w, Filterless Class D Amplifiers With Active Crossover
• Manufacturer: Maxim Integrated Products, Inc.

(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
go to www.maxim-ic.com/packages.)
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 25
© 2005 Maxim Integrated Products
The MAX9706/MAX9707 Thin QFN-EP package features an exposed thermal pad on its underside. This pad lowers the pack-
age’s thermal impedance by providing a direct heat conduction path from the die to the printed circuit board. The exposed
thermal pad is not internally connected. Connect the exposed pad to GND.
3-Channel, 2.3W, Filterless Class D Amplifiers
NOTES:
10. WARPAGE SHALL NOT EXCEED 0.10 mm.
11. MARKING IS FOR PACKAGE ORIENTATION REFERENCE ONLY.
12. NUMBER OF LEADS SHOWN FOR REFERENCE ONLY.
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220, EXCEPT FOR 0.4mm LEAD PITCH PACKAGE T4866-1.
ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.
FROM TERMINAL TIP.
SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE
D
D/2
E/2
E
Printed USA
e
A1
A2
A
L1
L
(ND-1) X e
with Active Crossover
is a registered trademark of Maxim Integrated Products, Inc.
e
L
L
k
C L
(NE-1) X e
e
E2
C L
PACKAGE OUTLINE
36, 40, 48L THIN QFN, 6x6x0.8mm
PACKAGE OUTLINE
36, 40, 48L THIN QFN, 6x6x0.8mm
E2/2
21-0141
21-0141
D2/2
k
b
Package Information
C L
C L
D2
e
F
F
L
1
2
2
2