adf4360-1 Analog Devices, Inc., adf4360-1 Datasheet - Page 17

• Manufacturer Part Number: adf4360-1
• Description: Integrated Synthesizer And Vco
• Manufacturer: Analog Devices, Inc.

Hardware Power-Up/Power-Down
If the ADF4360-1 is powered down via the hardware (using the
CE pin) and powered up again without any change to the N
counter register during power-down, it locks at the correct fre-
quency because the part is already in the correct frequency
band. The lock time depends on the value of capacitance on the
C
pacitance of 440 nF on this pin enables lock times of <600 µs.
The N counter value cannot be changed while the part is in
power-down because it may not lock to the correct frequency
on power-up. If it is updated, the correct programming se-
quence for the part after power-up is to the R counter latch,
followed by the control latch, and finally the N counter latch,
with the required interval between the control latch and N
counter latch, as described in the Initial Power-Up section.
N
pin, which is <5 ms for 10 µF capacitance. The smaller ca-
Rev. B | Page 17 of 24
Software Power-Up/Power-Down
If the ADF4360-1 is powered down via the software (using the
control latch) and powered up again without any change to the
N counter latch during power-down, it locks at the correct fre-
quency because it is already in the correct frequency band. The
lock time depends on the value of capacitance on the C
which is <5 ms for 10 µF capacitance. The smaller capacitance
of 440 nF on this pin enables lock times of <600 µs.
The N counter value cannot be changed while the part is in
power-down because it may not lock to the correct frequency
on power-up. If it is updated, the correct programming se-
quence for the part after power-up is to the R counter latch,
followed by the control latch, and finally the N counter latch,
with the required interval between the control latch and N
counter latch, as described in the Initial Power-Up section.
ADF4360-1
N
pin,