s-35399a02 Seiko Instruments Inc., s-35399a02 Datasheet - Page 34

• Manufacturer Part Number: s-35399a02
• Description: 2-wire Real-time Clock
• Manufacturer: Seiko Instruments Inc.

34
Power supply
Clock pulse
of real-time
second data
"00h"
24-bit binary
2-WIRE REAL-TIME CLOCK
S-35399A02
up counter
32.768 kHz Output Pins
Timing of Clock Output from F32K Pin
Up-Count Operation
The S-35399A02 outputs a 32.768 kHz clock pulse from the
kHz from these three pins simultaneously because stability of the crystal oscillator is affected.
When using the function to clock-correction or adjusting the oscillation frequency, measure the oscillation frequency under
the usage conditions. For example, when using 32.768 kHz clock pulse which is output from the FOUT pin, measure this IC
while the pulse is being output from the pin.
The 32.768 kHz clock pulse of the oscillation frequency is output from the F32K pin. The F32K pin has an Nch open-drain
output. When the CTRL pin is in “H”, the clock pulse is output, and when the CTRL pin is in “L” or open, the F32K pin is in
high impedance. To output 32.768 kHz from the F32K pin, set the CTRL pin to “H” when one sec or more has elapsed after
power-on.
The up counter is a 24-bit read-only binary counter. This counter starts counting from “000000h” from power-on and returns
to “000000h” at the next clock after it has reached “FFFFFFh”. A clock pulse is a pulse that is output when the second-data
in the real-time data is “00h”. Therefore, some delay is made in the period that a clock pulse is being output due to Write
timing and Write data. The registers are not initialized unless power-on again, so that users are able to grasp the elapsed
time from power-on up to 30 years. Figure 39 shows the example of timing chart of up counter’s operation.
CTRL pin
F32K pin
OFF
60 seconds or more.
A clock pulse is
Write real-time
ON
second data:
40 s
20 seconds
000000 h
ON
40 s
Figure 39 Timing Chart of 24-Bit Binary Up Counter
Figure 38 Timing of Clock Output from F32K Pin
000001 h 000010 h
60 s
60 seconds or less.
Write real-time
A clock pulse is
second data:
50 seconds
Seiko Instruments Inc.
20 s
10 s
INT
1
,
F32K, and FOUT pins. However, do not output 32.768
FFFFFF h
60 s
000000 h
60 s
OFF
000001 h
Rev.1.0
OFF
_00