mpc82l54 Megawin Technology, mpc82l54 Datasheet - Page 47

• Manufacturer Part Number: mpc82l54
• Description: 8-bit Micro-controller
• Manufacturer: Megawin Technology

Serial Peripheral Interface (SPI)
MEGAWIN
The device provides another high-speed serial communication interface, the SPI interface.
The SPI is a full-duplex, high-speed, synchronous communication bus with two operation
modes: Master mode and Slave mode. Up to 3Mbit/s can be supported in either Master or
Slave mode under the Fosc=12MHz. Two status flags are provided to signal the transfer
completion and write-collision occurrence.
There are three pins implementing the SPI functionality. One of them is SPICLK (P1.7), next is
MISO (P1.6), and the last is MOSI (P1.5). An extra pin SS (P1.4) is designed to configure the
SPI to run under Master or Slave mode. Data flows from master to slave via MOSI (Master
Out Slave In) pin, and flows from slave to master via MISO (Master In Slave Out) pin. The
SPICLK plays as an output pin when the device works under Master mode. At the same time,
as an input pin when the device works under Slave mode. If the SPI system is disabled, i.e.,
SPEN (SPICTL.6) =0, these pins are configured as general-purposed I/O port (P1.4 ~ P1.7).
Two devices with SPI interface communicate with each other via one synchronous clock
signal, i.e., one input data signal, and one output data signal. There are two concerns the user
could take care. One of them is latching data on the negative edge or positive edge of the
clock signal which named polarity. And the other is keeping the clock signal low or high while
the device idle which named phase. Permuting those states from polarity and phase, there
Fosc
Clock Divider
128
16,
64
4,
SSIG
SPIF
MPC82x54A Data Sheet
WCOL
SPEN
Shift In Register
Shift Out Register
SPI block diagram
DORD
SPI Control
-
MSTR
-
CPOL
-
CPHA
-
SPR1
-
SPR0
I/O control
-
SPISTAT
SPICTL
(SPICLK)
(MISO)
(MOSI)
P1.6
P1.5
P1.7
P1.4
(SS)
47