v23806-a34-c2 Infineon Technologies Corporation, v23806-a34-c2 Datasheet - Page 5

• Manufacturer Part Number: v23806-a34-c2
• Description: Single Mode Fddi Transceiver With Receptacle
• Manufacturer: Infineon Technologies Corporation

APPLICATION NOTE
Single Mode 1x9 Transceiver
* Recommended choke is Siemens Matsushita B78108-S1153-K or B78148-S1153-K (Q
The power supply filtering is recommended for good EMI per-
formance. Use short tracks from the inductor L1/L2 to the mod-
ule V
module for getting good EMI and sensitivity performance.
Studs should be connected to this V
contains an automatic shutdown circuit.
Published by Infineon Technologies AG
©
All Rights Reserved
Attention please!
The information herein is given to describe certain components and shall not be
considered as warranted characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties
of non-infringement, regarding circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices
please contact the Infineon Technologies offices or our Infineon Technologies
Representatives worldwide - see our webpage at
www.infineon.com/fiberoptics
Infineon Technologies AG • Fiber Optics • Wernerwerkdamm 16 • Berlin D-13623, Germany
Infineon Technologies, Inc. • Fiber Optics • 1730 North First Street • San Jose, CA 95112, USA
Infineon Technologies K.K. • Fiber Optics • Takanawa Park Tower • 20-14, Higashi-Gotanda, 3-chome, Shinagawa-ku • Tokyo 141, Japan
C1/3 = 4.7 µF
C2/4 = 4.7 µF
L1/2 = 15 µH (L2 optional)*
Infineon Technologies AG 1999
V
CC
CC
–RX/V
V
CC
EE
C1
–TX. We recommend a V
TxDN
TxD
L1
V
EE
C2
V
CC
-Tx
R1
R2
V
EE
EE
V
plane. The transceiver
EE
EE
R3
R4 S2
plane under the
DC coupling between ECL gates
TxV
V
EE
9
EE
Transceiver
Top View
Reset is only possible if the power is turned off, and then on
again. V
electrical interfacing are available upon request. Ask for App-
note 82.
Application board available on request.
Warnings
Due to technical requirements components may contain dangerous substances.
For information on the types in question please contact your Infineon Technologies
offices.
Infineon Technologies Components may only be used in life-support devices or
systems with the express written approval of Infineon Technologies, if a failure of
such components can reasonably be expected to cause the failure of that
life-support device or system, or to affect the safety or effectiveness of that device
or system. Life support devices or systems are intended to be implanted in the
human body, or to support and/or maintain and sustain and/or protect human life.
If they fail, it is reasonable to assume that the health of the user or other persons
may be endangered.
RxV
V
EE
1
S1
EE
CC
min
TX switched below V
R9
=60, max. DC resistance=0.6
V
EE
R5
V
EE
R6
V
EE
R7
R8
V
CC
RxDN
TH
-Rx
RxD
SD
. Further application notes for
V
EE
R1/3/5/7 = 82
R2/4/6/8 = 127
R9
C3
).
L2
= 510
V
EE
C4
V
CC