sle30b6vy Banner Engineering Corp., sle30b6vy Datasheet - Page 2

• Manufacturer Part Number: sle30b6vy
• Description: Optical Slot Sensors
• Manufacturer: Banner Engineering Corp.

SLE10/SLE30 Expert
TEACH-mode slot sensors
* Typical excess gain: indication of the sensitivity of the sensor. A minimum value of 1 is required to switch the sensor on.
Static and Dynamic Teach features
Setting the sensitivity of the SLE... sensor is performed in Teach
mode. The sensor offers two methods for programming: Static
Teach and Dynamic Teach. Use the built-in push button or the
remote teach input for either method.
Static Teach
The sensitivity is automatically set when the sensor is taught the
ON and OFF conditions. (The first condition taught is the ON
condition.) Press and hold the push button for minimum 2
seconds to enter Teach mode. Then, when the push button is
clicked, the sensor will sample each sensing condition and regis-
ter this into its memory. After the second sensing condition is
registered, the SLE... Expert automatically sets the sensitivity to
the optimum value for the application, and then returns to RUN
mode. If sensing contrast is not acceptable, the sensor will return
to the beginning of Teach mode.
Subject to changes without notice • Edition 02.02 • P/N ED060 – excerpt from EC001/0102
Optical slot sensors
!
These sensors do not include the self-checking redundant circuitry necessary to allow their use in personnel safety applica-
tions. A sensor failure or malfunction can result in either an energised or de-energised output condition. These products
should not be used as sensing devices for personnel safety.
TM
150
150
150
150
80
80
80
80
10 mm
10 mm
10 mm
10 mm
30 mm
30 mm
30 mm
30 mm
red
red
red
red
red
red
red
red
pnp, npn
pnp, npn
pnp, npn
pnp, npn
pnp, npn
pnp, npn
pnp, npn
pnp, npn
Dynamic Teach
This is a method of setting the sensor’s sensitivity while the object
to be sensed is in motion. When detecting small parts, aligning
the objects to the sensor’s effective beam can be difficult with the
Static Teach method. In this case, Dynamic Teach will allow you
to pass individual or multiple parts through the beam; the sensor
will detect them and set the sensitivity automatically.
When detecting labels, web flutter may change the amount of
light passing through the label and its backing material. Dynamic
Teach will sense this variation and adjust the sensitivity according-
ly. Dynamic Teach is activated after accessing Teach mode (press
and hold the push button for a minimum of 2 seconds), and then
double-click the push button. While the object to be sensed is in
motion, push in and hold the button. As long as the button is
held, the sampling will continue. Upon release of the button, the
sensor chooses the optimum setting for the application and
returns to RUN mode. If sensing contrast is not acceptable, the
sensor will return to Static Teach mode; double click the push
button to initiate Dynamic Teach.
connector
connector
connector
connector
cable
cable
cable
cable
SLE10B6V
SLE10B6VQ
SLE10B6VY
SLE10B6VYQ
SLE30B6V
SLE30B6VQ
SLE30B6VY
SLE30B6VYQ
30 603 80
30 603 81
30 603 82
30 603 83
30 554 74
30 554 76
30 554 75
30 554 77