isd4003 Winbond Electronics Corp America, isd4003 Datasheet - Page 13

• Manufacturer Part Number: isd4003
• Description: Single-chip, Multiple-messages Voice Record/playback Devices 4-, 5-, 6-, And 8-minute Duration
• Manufacturer: Winbond Electronics Corp America

Microcontroller Interface
A four-wire (SCLK, MOSI, MISO &
functions. The ISD4003 is configured to operate as a peripheral slave device, with a microcontroller-
based SPI bus interface. Read and write operations are controlled through this SPI interface. An
interrupt signal (
Programming
The ISD4003 series is also ideal for playback-only applications, where single- or multiple-messages
playback is controlled through the SPI port. Once the desired message configuration is created,
duplicates can easily be generated via a programmer.
The ISD4003 series operates via SPI serial interface with the following protocol.
First, the data transfer protocol assumes that the microcontroller’s SPI shift registers are clocked on
the falling edge of the SCLK. However, for the ISD4003, the protocols are as follows:
7.2. S
1. All serial data transfers begin with the falling edge of
2.
3. Data is clocked in on the rising edge of the SCLK signal and clocked out on the falling edge of
4. Playback and record operations are initiated when the device is enabled by asserting the
5. The opcodes contain <11 address bits> and <5 control bits>.
6. Each operation that ends with an EOM or Overflow will generate an interrupt. The Interrupt
7. As Interrupt data is shifted out of the MISO pin, control and address data are simultaneously
8. An operation begins with the RUN bit set and ends with the RUN bit reset.
9. All operations begin after the rising edge of
the SCLK signal, with LSB first.
pin LOW, shifting in an opcode and an address data to the ISD4003 device (refer to the
Opcode Summary in the following page).
will be cleared the next time a SPI cycle is initiated.
shifted into the MOSI pin. Care should be taken such that the data shifted in is compatible
with current system operation. Because it is possible to read an interrupt data and start a new
operation within the same SPI cycle.
SS
ERIAL
is held LOW during all serial communications and held HIGH between instructions.
P
INT
ERIPHERAL
) and internal read only Status Register are provided for handshake purposes.
I
NTERFACE
SS
(SPI) D
) SPI interface is provided for controlling and addressing
ESCRIPTION
- 13 -
SS
.
SS
Publication Release Date: July 16, 2007
pin.
ISD4003 SERIES
Revision 1.3
SS