m24c32 STMicroelectronics, m24c32 Datasheet - Page 9
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
m24c32
Manufacturer Part Number
m24c32
Description
64/32 Kbit Serial I??c Bus Eeprom
Manufacturer
STMicroelectronics
Datasheet
1.M24C32.pdf
(26 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
m24c32-FMB5TG
Manufacturer:
ST
Quantity:
500
Company:
Part Number:
m24c32-FMB5TG
Manufacturer:
MAXIM
Quantity:
142
Part Number:
m24c32-FMB5TG
Manufacturer:
ST
Quantity:
20 000
Figure 7. Write Mode Sequences with WC=1 (data write inhibited)
Write Operations
Following a Start condition the bus master sends
a Device Select Code with the Read/Write bit
(RW) reset to 0. The device acknowledges this, as
shown in
bytes. The device responds to each address byte
with an acknowledge bit, and then waits for the
data byte.
Writing to the memory may be inhibited if Write
Control (WC) is driven High. Any Write instruction
with Write Control (WC) driven High (during a pe-
riod of time from the Start condition until the end of
the two address bytes) will not modify the memory
contents, and the accompanying data bytes are
not acknowledged, as shown in
Each data byte in the memory has a 16-bit (two
byte wide) address. The Most Significant Byte
ble
cant Byte
address of the byte in memory.
When the bus master generates a Stop condition
immediately after the Ack bit (in the “10
4.) is sent first, followed by the Least Signifi-
WC
BYTE WRITE
WC
PAGE WRITE
WC (cont'd)
PAGE WRITE
(cont'd)
Figure
(Table
8., and waits for two address
5.). Bits b15 to b0 form the
NO ACK
DEV SEL
DEV SEL
Figure
DATA IN N
R/W
R/W
ACK
ACK
7..
th
NO ACK
BYTE ADDR
BYTE ADDR
bit” time
(Ta-
ACK
ACK
slot), either at the end of a Byte Write or a Page
Write, the internal Write cycle is triggered. A Stop
condition at any other time slot does not trigger the
internal Write cycle.
After the Stop condition, the delay t
cessful completion of a Write operation, the de-
vice’s internal address counter is incremented
automatically, to point to the next byte address af-
ter the last one that was modified.
During the internal Write cycle, Serial Data (SDA)
is disabled internally, and the device does not re-
spond to any requests.
Byte Write
After the Device Select code and the address
bytes, the bus master sends one data byte. If the
addressed location is Write-protected, by Write
Control (WC) being driven High, the device replies
with NoAck, and the location is not modified. If, in-
stead, the addressed location is not Write-protect-
ed, the device replies with Ack. The bus master
terminates the transfer by generating a Stop con-
dition, as shown in
BYTE ADDR
BYTE ADDR
ACK
ACK
DATA IN 1
DATA IN
Figure
NO ACK
NO ACK
8..
DATA IN 2
M24C64, M24C32
AI01120C
W
, and the suc-
9/26