stcf03i STMicroelectronics, stcf03i Datasheet - Page 13

• Manufacturer Part Number: stcf03i
• Description: High Power White Led Driver With I2ctm Interface
• Manufacturer: STMicroelectronics

7
7.1
7.2
7.2.1
7.2.2
7.2.3
13/33
Introduction
The STCF03I is a buck-boost converter, dedicated to power and control the current of a
Power White LED in a camera cell phone. The device operates at a constant switching
frequency of 1.8 MHz typ. It provides an output voltage down to 2.5 V and up to 5.3 V, from
a 2.7 V to 5.5 V supply voltage. This supply range allows operation from a single cell
Lithium-Ion battery. The I
purposes. The current in Torch mode is adjustable from 15 mA to 200 mA. Flash mode
current is adjustable up to 800mA for an input voltage ranging from 3.3 V to 5.5 V and up to
600mA for an input voltage ranging from 2.7 V to 5.5 V. The Aux LED current can be
adjusted from 0 to 20 mA. The device uses an external NTC resistor to sense the
temperature of the white LED. These two last functions may not be needed in all
applications, and in these cases the relevant external components can be omitted.
Buck-Boost converter
The regulation of the PWM controller is done by sensing the current of the LED through
external sensing resistors (R
forward voltage of the Flash LED, the device automatically can change the operation mode
between buck (step down) and boost (step up) mode.
Three cases can occur: Boost region (V
as the output voltage V
Buck / Boost region (V
Logic pin description
SCL, SDA pins
These are the standard Clock and Data pins as defined in the I
pull-up is required according to I
of these signals should be 3.0 V.
TRIG pin
This input pin is internally AND-ed with the TRIG_EN bit to generate the internal signal that
activates the flash operation. This gives to the user the possibility to accurately control the
flash duration using a dedicated pin, avoiding the I
internal pull-up nor pull-down is provided.
ATN pin
This output pin (open-drain, active LOW) is provided to better manage the information
transfer from the STCF03I to the µP. Because of the limitations of a Single Master I
configuration, the µP should regularly poll the STCF03I to verify if certain operations have
been completed, or to check diagnostic information. Alternatively, the µP can use the ATN
pin to be advised that new data are available in the STAT_REG, thus avoiding continuous
polling. Then the information can be read in the STAT_REG by a read operation via I
besides, automatically resets the ATN pin. The STAT_REG bits affecting the ATN pin status
are mapped in
Table
16. No internal pull-up is provided.
O
O
~ V
= V
2
C bus is used to control the device operation and for diagnostic
BAT
fLED
FL
).
and R
2
+ I
C bus specifications. The recommended maximum voltage
LED
TR
x R
, see application schematic). Depending on the
O
> V
FL
) is higher than V
BAT
): this configuration is used in most cases,
2
C bus latencies (hard-triggering). No
2
BAT
C bus specification. External
; Buck region (V
O
2
< V
2
C bus
C that,
BAT
);