ncv8769 ON Semiconductor, ncv8769 Datasheet - Page 11

• Manufacturer Part Number: ncv8769
• Description: Ultra Low Iq 150 Ma Ldo Regulator With Reset And Early Warning
• Manufacturer: ON Semiconductor

General
duty cycle techniques to maintain junction temperature as
close as possible to ambient temperature.
Output Voltage
temperature, input voltage and output current values or
specified over Line, Load and Temperature ranges.
Line Regulation
measured for specific output current over operating ambient
temperature range.
Load Regulation
current measured for specific input voltage over operating
ambient temperature range.
Dropout Voltage
output no longer maintains regulation against further
reductions in input voltage. It is measured when the output
drops 100 mV below its nominal value. The junction
temperature, load current, and minimum input supply
requirements affect the dropout level.
Quiescent Current
current (measured through the LDO input pin) and the
output load current.
Current Limit and Short Circuit Current Limit
voltage drops below 96% of its nominal value. It means that
All measurements are performed using short pulse low
The output voltage parameter is defined for specific
The change in output voltage for a change in input voltage
The change in output voltage for a change in output
The input to output differential at which the regulator
Quiescent Current (I
Current Limit is value of output current by which output
q
) is the difference between the input
http://onsemi.com
DEFINITIONS
11
the device is capable to supply minimum 200 mA without
sending Reset signal to microprocessor.
measured with output of the regulator shorted to ground.
PSRR
voltage and input voltage ripple. It is measured in decibels
(dB).
Line Transient Response
response when the input voltage is excited with a given
slope.
Load Transient Response
response when the output current is excited with a given
slope between low−load and high−load conditions.
Thermal Protection
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 175°C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
dissipation for particular package or power dissipation at
which the junction temperature reaches its maximum
operating value, whichever is lower.
Short Circuit Current Limit is output current value
Power Supply Rejection Ratio is defined as ratio of output
Typical output voltage overshoot and undershoot
Typical output voltage overshoot and undershoot
Internal thermal shutdown circuitry is provided to protect
The power dissipation level is maximum allowed power