stm6823sjwy6f STMicroelectronics, stm6823sjwy6f Datasheet - Page 11

• Manufacturer Part Number: stm6823sjwy6f
• Description: 5-pin Supervisor With Watchdog Timer And Push-button Reset
• Manufacturer: STMicroelectronics

2.3
2.4
Note:
2.5
2.5.1
2.5.2
Push-button reset input (STM6322/6821/6822/6823/6825)
A logic low on MR asserts reset. Reset remains asserted while MR is low, and for t
Figure 25 on page
resistor, allowing it to be left open if not used. This input can be driven with TTL/CMOS-logic
levels or with open-drain/collector outputs. Connect a normally open momentary switch from
MR to GND to create a manual reset function; external debounce circuitry is not required. If
MR is driven from long cables or the device is used in a noisy environment, connect a 0.1µF
capacitor from MR to GND to provide additional noise immunity. MR may float, or be tied to
V
Watchdog input (STM6321/6821/6822/6823/6824)
The watchdog timer can be used to detect an out-of-control MCU. If the MCU does not
toggle the Watchdog Input (WDI) within t
watchdog timer is cleared by either:
1.
2.
The timer remains cleared and does not count for as long as reset is asserted. As soon as
reset is released, the timer starts counting.
The watchdog function may be disabled by floating WDI or tri-stating the driver connected to
WDI. When tri-stated or disconnected, the maximum allowable leakage current is 10µA and
the maximum allowable load capacitance is 200pF.
Applications information
Watchdog input current
The WDI input is internally driven through a buffer and series resistor from the watchdog
counter. For minimum watchdog input current (minimum overall power consumption), leave
WDI low for the majority of the watchdog time-out period. When high, WDI can draw as
much as 160µA. Pulsing WDI high at a low duty cycle will reduce the effect of the large input
current. When WDI is left unconnected, the watchdog timer is serviced within the watchdog
time-out period by a low-high-low pulse from the counter chain.
Ensuring a valid reset output down to V
The STM6xxx Supervisors are guaranteed to operate properly down to V
applications that require valid reset levels down to V
low outputs (push/pull only, see
outputs (push/pull only, see
while the reset output can no longer sink or source current. This scheme does not work with
the open drain outputs of the STM6321/6322/6822.
The resistor value used is not critical, but it must be large enough not to load the reset
output when V
CC
when not used.
a reset pulse, or
by toggling WDI (high-to-low or low-to-high), which can detect pulses as short as 50ns.
CC
is above the reset threshold. For most applications, 100kΩ is adequate.
19) after it returns high. The MR input has an internal 52kΩ pull-up
Figure 13 on page
Figure 12 on page
WD
(1.6sec), the reset is asserted. The internal
12) will ensure that the reset line is valid
12) and a pull-up resistor to active-high
CC
CC
= 0V
= 0, a pull-down resistor to active-
CC
= 1V. In
rec
(see
11/26