Network
Camera/JPEG Encoder
Others
DESCRIPTION
S1S65010 is an optimum network camera controller IC for configuring Internet cameras. In addition to network/protocol
process function, it also has camera interface and JPEG encoder function. Connecting a Flash ROM stored with a
camera module, PHY for Ethernet and firmware to the S1S65010 enables simple configuration of the Internet camera.
Image capturing from cameras and JPEG encoding is executed at the receipt of shutter command from a client. When
the S1S65010 is operated as an HTTP server on the LAN, it sends image files to the client upon request. Capturing
images and sending them to the designated client can be done full time, or at a constant frequency using internal timer,
or at a trigger on an interrupt pin using external sensors or other device. Images can be sent as an attachment to the
e-mail.
S1S65010, equipped with GPIO and I
these ports through the network. A sample software is supplied with this product.
FEATURES
SPECIFICATIONS
Sample protocols
Physical layer interface
Camera interface
Resolution
JPEG encoder
Camera input data format
Frame rate
Built-in memory
general-purpose I/O
Serial EEPROM interface
I
I
External Flash ROM
Compact Flash Card interface
Expandable memory
Supply voltage
Package
2
2
C bus
S bus
Network Camera Controller with JPEG Encoder
cycle.
Enables the function of the internet camera without PC
Compatible with S1S65000 pins. Software upper compatible with S1S65000.
Realizes 30fps@VGA frame rate as a network camera.
Works with a variety of camera modules up to 2 mega pixels (approx. 2 million pixels).
Supports I
Compresses images in JPEG format with hardware JPEG encoder (complies with ISO 10918)
Can configure various control settings via the network
Can send Images via e-mail
Can save power consumption by using wake-up mode that changes status of start, shoot and pause on a regular
Has a Compact Flash interface for a CF memory card or a wireless LAN interface (802.11b/g).
One-chip solution, which can reduce system cost.
ARM720T Rev 4.3 is built-in (with 8KB cache) 50MHz
2
S for voice/audio data.
SEIKO EPSON CORPORATION
2
C bus, can configure cameras and control external devices such as a motor via
ARP, ICMP, IP, TCP, UDP, HTTPd, SMTP, DHCP, FTP
Can add or update supported protocols by rewriting Flash ROM.
Complies with Media Independent Interface (IEEE 802.3 Clause 22)
Supports 10/100 Base half-duplex and full-duplex.
8-bit parallel interface
Pixel clock frequency for inputting camera data is less than 2/3 of CPU clock
frequency.
Up to 1600 × 1200 approx. (UXGA, SXGA, XGA, VGA, QVGA, CIF, QCIF)
Hardware encoder with processing capacity of 30 fps@VGA or more
Complies with YUV4:2:2 progressive camera (ITU-R BT656 Non Interlace)
Up to 30fps (VGA)
For CPU Work and JPEG/Ethernet: processing: Up to 78KB
57 pcs (at max.)
Clock synchronous
Master (for camera control or general-purpose)
For input/output of voice/audio
Up to 16MB
Complies with CF+spec. Rev.1.4. Also support True IDE mode.
SDRAM 2 - 128MB (Static memory available: up to 16MB)
1.8V (core), 3.3V (I/O), 2.4-3.6V (Camera I/O)
TQFP24-144pin (16 ×16 × 1 mm, 0.4mm pin pitch)
S1S65010