op27grbc Analog Devices, Inc., op27grbc Datasheet - Page 7

• Manufacturer Part Number: op27grbc
• Description: Low-noise, Precision Operational Amplifier
• Manufacturer: Analog Devices, Inc.

ABSOLUTE MAXIMUM RATINGS
Table 5.
Parameter
Supply Voltage
Input Voltage
Output Short-Circuit Duration
Differential Input Voltage
Differential Input Current
Storage Temperature Range
Operating Temperature Range
Lead Temperature Range (Soldering, 60 sec)
Junction Temperature
1
2
ESD CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate on
the human body and test equipment and can discharge without detection. Although this product features
proprietary ESD protection circuitry, permanent damage may occur on devices subjected to high energy
electrostatic discharges. Therefore, proper ESD precautions are recommended to avoid performance
degradation or loss of functionality.
For supply voltages less than ±22 V, the absolute maximum input voltage is
equal to the supply voltage.
The inputs of the OP27 are protected by back-to-back diodes. Current
limiting resistors are not used in order to achieve low noise. If differential
input voltage exceeds ±0.7 V, the input current should be limited to 25 mA.
OP27A (J, Z)
OP27E, ( Z)
OP27E, (P)
OP27G (P, S, J, Z)
1
2
2
Rating
±22 V
±22 V
Indefinite
±0.7 V
±25 mA
−65°C to +150°C
−55°C to +125°C
−25°C to +85°C
0°C to 70°C
−40°C to +85°C
300°C
−65°C to +150°C
Rev. F | Page 7 of 20
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
THERMAL RESISTANCE
θ
specified for device in socket for TO, CERDIP, and PDIP
packages; θ
board for SO package.
Absolute maximum ratings apply to both DICE and packaged
parts, unless otherwise noted.
Table 6.
Package Type
TO-99 (J)
8-Lead Hermetic DlP (Z)
8-Lead Plastic DIP (P)
8-Lead SO (S)
JA
is specified for the worst-case conditions, that is, θ
JA
is specified for device soldered to printed circuit
θ
150
148
103
158
JA
θ
18
16
43
43
JC
JA
Unit
°C/W
°C/W
°C/W
°C/W
is
OP27