pa050xs1 AZ Displays, Inc, pa050xs1 Datasheet - Page 22

• Manufacturer Part Number: pa050xs1
• Description: This Technical Specification Applies To 5inch Color Tft-lcd Module , Pa050xs1.
• Manufacturer: AZ Displays, Inc

11. Handling Cautions
The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be distributed,
reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co., Ltd.
11-1) Mounting of module
11-2) Precautions in mounting
11-3) Adjusting module
11-4) Others
a) Please power off the module when you connect the input/output connector.
b) Please connect the ground pattern of the inverter circuit surely. If the connection
c) Polarizer which is made of soft material and susceptible to flaw must be
a) When metal part of the TFT-LCD module (shielding lid and rear case) is soiled,
b) Wipe off water drops or finger grease immediately. Long contact with water may
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or bumped on hard surface.
d) Since CMOS LSI is used in the module. So take care of static electricity and
a) Adjusting volumes on the rear face of the module have been set optimally before shipment.
b) Therefore, do not change any adjusted values. If adjusted values are changed, the specifications
a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many
b) Store the module at a room temperature place.
c) The voltage of beginning electric discharge may over the normal voltage because of leakage
d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.
e) Observe all other precautionary requirements in handling general electronic components.
f) Please adjust the voltage of common electrode as material of attachment by 1 module.
d) Protective film (Laminator) is applied on surface to protect it against scratches
1. The noise from the backlight unit will increase.
2. The output from inverter circuit will be unstable.
3. In some cases a part of module will heat.
handled carefully.
and dirts. It is recommended to peel off the laminator before use and taking
care of static electricity.
wipe it with soft dry cloth.
cause discoloration or spots.
Please handle with care.
earth yourself when handling.
described may not be satisfied.
hours.
current from approach conductor by to draw lump read lead line around.
Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes or feet. Wash it
out immediately with soap.
is not perfect, some following problems may happen possibly.
PA050XS1
PAGE:22