wm9090 Wolfson Microelectronics plc, wm9090 Datasheet - Page 75

no-image

wm9090

Manufacturer Part Number
wm9090
Description
Ultra Low Power Audio Subsystem
Manufacturer
Wolfson Microelectronics plc
Datasheet
WM9090
Pre-Production
A simple equivalent circuit of a loudspeaker consists of a serially connected resistor and inductor, as
shown in Figure 21. This circuit provides a low pass filter for the speaker output. If the loudspeaker
characteristics are suitable, then the loudspeaker itself can be used in place of the filter components
described earlier. This is known as ‘filterless’ operation.
Figure 21 Speaker Equivalent Circuit for Filterless Operation
For filterless Class D operation, it is important to ensure that a speaker with suitable inductance is
chosen. For example, if we know the speaker impedance is 8Ω and the desired cut-off frequency is
20kHz, then the optimum speaker inductance may be calculated as:
8Ω loudspeakers typically have an inductance in the range 20μH to 100μH, however, it should be
noted that a loudspeaker inductance will not be constant across the relevant frequencies for Class D
operation (up to and beyond the Class D switching frequency). Care should be taken to ensure that
the cut-off frequency of the loudspeaker’s filtering is low enough to suppress the high frequency
energy of the Class D switching and, in so doing, to prevent speaker damage. The Class D outputs
of the WM9090 operate at much higher frequencies than is recommended for most speakers and it
must be ensured that the cut-off frequency is low enough to protect the speaker.
PP, January 2010, Rev 3.0
w
75

Related parts for wm9090