msm9210 Oki Semiconductor, msm9210 Datasheet - Page 6

• Manufacturer Part Number: msm9210
• Description: 32-bit Duplex/triplex 1/2 Duty / 1/3 Duty Vf Controller/driver With Digital Dimming
• Manufacturer: Oki Semiconductor

¡ Semiconductor
PIN DESCRIPTIONS
SEG23 to 32
SEG1 to 22
GRID1 to 3
Symbol
DUP/TRI
DATA IN
D-GND
CLOCK
DIM IN
L-GND
V
M/S
V
CS
DISP
DD
30 to 42,
44 to 48,
9, 10, 11
50 to 53
QFP56
12, 49
1 to 8,
54, 55
43,56
14
21
18
19
20
24
25
15
Pin
10, 11, 12
34 to 46,
51 to 55,
57 to 60
QFP64
13, 56
2 to 9,
61, 62
49,64
15
24
21
22
23
27
28
18
Type
—
—
—
—
O
O
O
I
I
I
I
I
I
Power supply pins for VFD driver circuit.
43 pin and 56 pin should be connected externally.
Power supply pin for logic drive.
D-GND is ground pin for the VFD driver circuit. L-GND is ground
pin for the logic circuit. 12pin, 21pin and 49pin should be
connected externally.
Segment (anode) signal output pins for a VFD tube.
These pins can be directly connected to the VFD tube.
External circuit is not required.
IOH£–5 mA
Segment (anode) signal output pins for a VFD tube.
These pins can be directly connected to the VFD tube.
External circuit is not required.
IOH£–10 mA
Inverted Grid signal output pins.
For pre-driver, the external circuit is required.
IOL£10 mA
Chip select input pin.
Data is not transferred when CS is set to a Low level.
Shift clock input pin.
Serial data shifts at the rising edge of the CLOCK.
Serial data input pin (positive logic).
Data is input to the shift register at the rising edge of the CLOCK signal.
Duplex/Triplex operation select input pin.
Duplex (1/2 duty) operation is selected when this pin is set to V
Triplex (1/3 duty) operation is selected when this pin is set to L-GND.
Master/Slave mode select input pin.
Master mode is selected when this pin is set to V
Slave mode is selected when this pin is set to L-GND.
Dimming pulse input.
When the slave mode is selected, the pulse width of the all segment
output are controlled by a input pulse width of DIM IN.
Connect this pin to the master side DIM OUT pin at the slave mode.
When the master mode is selected, the input level of this pin is
ignored and the pulse width of the all grids and segment outputs are
controlled by a built-in 10-bit dimming circuit.
Connect this pin to V
DD
or L-GND at the master mode.
Description
FEDL9210-04
DD
MSM9210
.
6/20
DD
.