msm7570l-01 Oki Semiconductor, msm7570l-01 Datasheet - Page 5

• Manufacturer Part Number: msm7570l-01
• Description: Multi-function Adpcm Codec Msm7570l-01/02multi-function Adpcm Codec
• Manufacturer: Oki Semiconductor

¡ Semiconductor
Differential analog outputs for sound output.
Control register data CR4-B5 determines the output pins (AOUT+ and AOUT- /SAO+ and SAO-
) for the voice signal and an acoustic component of the sound tone, DTMF tone, R tone, F tone,
and various types of tones at either the VFRO pin or the SAO+ and SAO- pins. The output load
conditions of these pins are the same as those of AOUT+ and AOUT-.
with 0.1 F ceramic type) between this pin and AG to get the specified noise characteristics.
During power-down, this output voltage is 0 V. The SG voltage if necessary should be used via
a beffer.
Digital ground.
This ground is separated from the analog signal ground pin (AG). The DG pin must be kept as
close as possible to AG on the PCB.
+3 V power supply.
Power down and reset control input.
A “0” level makes the IC enter a power down state. At the same time, all control register data are
reset to the initial state. Set this pin to “1” during normal operating mode. The power down state
is controlled by a logical OR with CR0-B5 of the control register. When using PDN/RESET for
power down and reset control, set CR0-B5 to digital “0”.
The reset width (during “L”) should be 200ns or more.
Master clock input.
The frequency must be 12.288 MHz or 19.2 MHz. The applied clock frequency is selected by the
control register data CR0-B6. The master clock signal may be asynchronous with BCLK, XSYNC,
and RSYNC.
SAO+, SAO–
SG
Analog signal ground.
The output voltage of this pin is approximately 1.4 V. Put the bypass capacitors (10 F in parallel
AG
Analog ground.
DG
V
PDN/RESET
MCK
DD
MSM7570L-01/02
5/26