h5cx-l8sd Omron Corporation, h5cx-l8sd Datasheet - Page 46

• Manufacturer Part Number: h5cx-l8sd
• Description: Digital Timer
• Manufacturer: Omron Corporation

■ Timing Charts
Note: Forecast Value = Set Value − Forecast Set Value
■ Self-diagnostic Function
The following displays will appear if an error occurs.
Note: This includes times when the life of the EEPROM has expired.
e1
e2
e2
Forecast value (SV 1)
Forecast value (SV 1)
Main display
Set value (SV 2)
Set value (SV 2)
The forecast set value is used to set the deviation for the set value.
Start signal
Start signal
Power
999999
Reset
Gate
OUT1
OUT2
999999
Power
Reset
OUT1
OUT2
Gate
0
0
The names in parentheses are used for the absolute value setting.
The names in parentheses are used for the absolute value setting.
Not lit
Not lit
sum
Sub-display
F-1 mode: Cumulative (Timer does not reset when power comes ON.)
A Mode: Signal ON delay (Timer resets when power comes ON.)
CPU
Memory error (RAM)
Memory error (EEP)
(See note)
Error
OFF
OFF
OFF
Output status
Either press the reset key or reset the
power supply.
Reset the power supply.
Reset to the factory settings using
the reset key.
(Control output 2)
•
•
Start signal input
(Control output 2)
•
•
(Control output 1)
Basic Operation
*
**
(Control output 1)
Start signal input
•
•
•
Basic Operation
*
Forecast output
Forecast output
Correction method
Timing starts when the start signal turns ON.
While the start signal is ON, the timer starts when the power
turns ON or when the reset input turns OFF.
A sustained control output is used.
Timing stops when the time is up.
Control output
Control output
Output is instantaneous when the set value is 0.
Output is instantaneous when the set value is 0.
Start signal input is disabled during timing.
Start signal enables timing (timing is stopped when the
start signal is OFF or when the power is OFF).
A sustained control output is used.
Timing continues even after the time is up.
Power
OUT2
OUT2
OUT1
Power
OUT1
**
The names in parentheses are used for the
absolute value setting.
The names in parentheses are used for
the absolute value setting.
Timing
Sustained
Timing
No change
No change
0
Set value after
H5CX-B
Timing
reset
46