smc256bfd6e STMicroelectronics, smc256bfd6e Datasheet - Page 35

• Manufacturer Part Number: smc256bfd6e
• Description: 32mbyte, 64mbyte, 128mbyte, 256mbyte, 512mbyte, 1gbyte, 2gbyte, And 4gbyte 3.3/5v Supply Compactflash Card
• Manufacturer: STMicroelectronics

SMCxxxBF
Table 27.
6.2
6.2.1
6.2.2
6.2.3
6.2.4
6.2.5
Conf5 Conf4 Conf3
0
0
0
0
0
0
0
0
CompactFlash Memory Card Configurations
Card Configuration and Status Register (202h in Attribute
Memory)
The Card Configuration and Status Register contains information about the Card’s status
(see
Changed
Indicates that one or both of the Pin Replacement register (CRDY, or CWProt) bits are set to
‘1’. When the Changed bit is set,
the Card is configured for the I/O interface.
SigChg
This bit is set and reset by the host to enable and disable a state-change signal from the
Status Register (issued on Status Changed pin 46). If no state change signal is desired, this
bit should be set ‘0’ and pin 46 (
I/O.
IOis8
The host sets this bit to ‘1’ if the Card is to be configured in 8 bit I/O Mode. The Card is
always configured for both 8 and 16 bit I/O, so this bit is ignored.
PwrDwn
This bit indicates whether the Card is in the power saving mode or active mode. When the
PwrDwn bit is set to ‘1’, the Card enters power down mode. When set to ‘0’, the Card enters
active mode. The READY value on Pin Replacement Register becomes BUSY when this bit
is changed. READY will not become Ready until the power state requested has been
entered. The Card automatically powers down when it is idle and powers back up when it
receives a command.
Int
This bit represents the internal state of the interrupt request. It is available whether or not
the I/O interface has been configured. It remains valid until the condition which caused the
interrupt request has been serviced. If interrupts are disabled by the
Control Register, this bit is ‘0’.
Table
0
0
0
0
28).
Conf2
0
0
0
0
Conf1
0
0
1
1
Conf0
0
1
0
1
–
STSCHG) will be held High while the Card is configured for
–
STSCHG (Pin 46) is held Low and if the SigChg bit is ‘1’
Mapping Mode
Contiguous I/O
Secondary I/O
Primary I/O
Memory
Memory
Mode
Card
I/O
I/O
I/O
Task File Register Address
1F0h - 1F7h, 3F6h - 3F7h
170h - 177h, 376h - 377h
0h - Fh, 400h - 7FFh
–
IEN bit in the Device
Card Configuration
xx0h - xxFh
35/91