jxp-01dmac1-230 JDS Uniphase Corporation, jxp-01dmac1-230 Datasheet - Page 17

• Manufacturer Part Number: jxp-01dmac1-230
• Description: Multiprotocol Xfp Optical Transceiver C-band Dwdm For Up To 80 Km Reach
• Manufacturer: JDS Uniphase Corporation

17
Section 4
Other information related to the transceiver includes:
• Section 4.1 Packing and Handling Instructions
• Section 4.2 ESD Discharge (ESD)
• Section 4.3 Eye Safety
4.1 Package and Handling Instructions
Connector covers
The transceiver is supplied with an LC duplex receptacle. The supplied connector
plug protects the connector during standard manufacturing processes and
handling by preventing contamination from dust, aqueous solutions, body oils,
or airborne particles.
Note: It is recommended that the connector plug remain on whenever the
transceiver optical fiber connector is not inserted.
Recommended cleaning and degreasing chemicals
JDSU recommends the use of methyl, isopropyl and isobutyl alcohols for cleaning.
Do not use halogenated hydrocarbons such as trichloroethane, ketones such as
acetone, chloroform, ethyl acetate, MEK, methylene chloride, methylene dichloride,
phenol, or N-methyl-2-pyrrolidone.
This product is not designed for aqueous wash.
Housing
The transceiver housing is made from zinc.
4.2 ESD Discharge (ESD)
Handling
Normal ESD precautions are required during the handling of this module. This
transceiver is shipped in ESD protective packaging. It should be removed from
the packaging and otherwise handled in an ESD-protected environment utilizing
standard grounded benches, floor mats, and wrist straps.
Test and operation
In most applications, the optical connector will protrude through the system
chassis and be subjected to the same ESD environment as the system. Once
properly installed in the system, this transceiver should meet and exceed common
ESD testing practices and fulfill system ESD requirements.
Typical of optical transceivers, this module’s receiver contains a highly sensitive
optical detector and amplifier which may become temporarily saturated during
an ESD strike. This could result in a short burst of bit errors. Such an event might
require that the application re-acquire synchronization at the higher layers (for
example, a serializer/deserializer chip).
MULTIPROTOCOL XFP OPTICAL TRANSCEIVER:
C-BAND DWDM FOR UP TO 80 KM REACH
Related Information