jxp-01lmad1 JDS Uniphase Corporation, jxp-01lmad1 Datasheet - Page 7

• Manufacturer Part Number: jxp-01lmad1
• Description: Multiprotocol Xfp Optical Transceiver --1310 Nm Dfb For Up To 10-km Reach
• Manufacturer: JDS Uniphase Corporation

Table 1. Transceiver pin descriptions
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
1. Module ground pins (GND) are isolated from the module case and chassis ground within the module.
2. Shall be pulled up with 4.7 kΩ – 10 kΩ to a voltage between 3.15 V and 3.45 V on the host board.
7
Type
LVTTL-I
LVTTL-O
LVTTL-I
LVTTL-I
LVTTL-I/O
LVTTL-O
LVTTL-O
LVTTL-O
CML-O
CML-O
LVTTL-I
PECL-I
PECL-I
CML-I
CML-I
Name
GND
VEE5
Mod_Desel
Interrupt
TX_DIS
VCC5
GND
VCC3
VCC3
SCL
SDA
Mod_Abs
Mod_NR
RX_LOS
GND
GND
RD-
RD+
GND
VCC2
P_Down/RST
VCC2
GND
RefCLK+
RefCLK-
GND
GND
TD-
TD+
GND
2
2
1
1
1
1
1
1
1
1
1
2
2
2
2
MULTIPROTOCOL XFP OPTICAL TRANSCEIVER
—1310 NM DFB FOR UP TO 10-KM REACH
Description
Module ground
Not used: may be left unconnected (optional -5.2 V power supply)
Module de-select: when held low, allows the module to respond to
two-wire serial interface commands.
Interrupt: indicates presence of an important condition which can be
read over the serial two-wire interface.
Transmitter disable: transmitter laser source turned off.
+5 V power supply (not used)
Module ground
+3.3 V power supply
+3.3 V power supply
Two-wire interface clock
Two-wire interface data line
Indicates module is not present. Grounded in the module.
Module not ready: indicating module operational fault.
Receiver loss of signal indicator
Module ground
Module ground
Receiver inverted data output
Receiver non-inverted data output
Module ground
+1.8 V power supply
Power down: when high, the module limits power consumption to
1.5 W or below. Serial interface is functional in the low power mode.
Reset: the falling edge initiates a complete reset of the module
including the serial interface, equivalent to a power cycle.
+1.8 V power supply
Module ground
Reference clock non-inverted input (not used)
Reference clock inverted input (not used)
Module ground
Module q
Transmitter inverted data input
Transmitter non-inverted data input
Module ground