gs-r24fp STMicroelectronics, gs-r24fp Datasheet - Page 9

• Manufacturer Part Number: gs-r24fp
• Description: 1.8 A Dc-dc Converter Modules
• Manufacturer: STMicroelectronics

GS-R24FP
4.6
4.7
4.8
Thermal shutdown
The shutdown block generates a signal that turns OFF the power stage if the temperature of
the internal chip goes higher than a fixed internal threshold (150 °C min).
The sensing element of the chip is very close to the PDMOS area, so ensuring an accurate
and fast temperature detection.
An hysteresis of approximately 20 °C avoids that the devices turns ON and OFF
continuously.
Output voltage programming (GS-R24FP0001.8 only)
The GS-R24FP0001.8 output voltage is 5.54 V ± 4 %, to reduce this value connect a resistor
between pin 10 (FB) and pin 9 (V
The resistor must be located very close to the proper pins, to minimize the injected noise
(see
The resistor value is calculated using the following formula:
for GS-R24FP0001.8 Rv = [(V
V
Loop compensation (GS-R24FP0001.8 only)
If required by particular load conditions, it is possible to change the feedback loop
compensation, adding an external capacitor between pin 10 (FB) and pin 9 (V
act as speed up (see
out
can be adjusted between 1.235 V (Rv = 0 Ω) and 5.54V (Rv = open)
Figure
4).
Figure
5).
out
- 1.235) * 11.3] / 5.54 - V
out
).
out
) --[kΩ]
Application information
out
), which will
9/15