CM3102-12SO CALMIRCO [California Micro Devices Corp], CM3102-12SO Datasheet - Page 2

no-image

CM3102-12SO

Manufacturer Part Number
CM3102-12SO
Description
Micropower 1.2V/150mA CMOS LDO Regulator with Power Good
Manufacturer
CALMIRCO [California Micro Devices Corp]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
CM3102-12SO
Manufacturer:
CALMICRO
Quantity:
20 000
Ordering Information
© 2004 California Micro Devices Corp. All rights reserved.
2
Note: This drawing is not to scale.
CM3102-12
Regulator
430 N. McCarthy Blvd., Milpitas, CA 95035-5112 L Tel: 408.263.3214
PIN
1
2
3
4
5
Note 1: Parts are shipped in Tape & Reel form unless otherwise specified.
NAME
GND
OUT
EN
PG
IN
Pins
5
DESCRIPTION
Positive input voltage for the regulator. The internal loading on this input is typically 300µA when-
ever the regulator is enabled, and less than 1µA when the regulator is disabled. Although an input
filter capacitor is not required, it is recommended that a 1µF ceramic capacitor be used for addi-
tional filtering and stability if this pin is greater than 2 inches from the main input filter.
The negative reference for all voltages.
Enable/shutdown input. When EN is asserted high (V
is asserted low (V
mode and an internal discharge resistance (500
put voltage to 0 volts.
Power Good output. This is an open drain output and functions as a supply voltage supervisor for
the output voltage. It is asserted low when the output falls below 89% of its nominal value. This out-
put becomes inactive when V
The regulated voltage output. An output capacitor of 1µF is recommended to minimize any tran-
sient load disturbances under normal operating conditions. Additional output capacitance can be
used to further improve transient load response.
PACKAGE / PINOUT DIAGRAM
Package
SOT23-5
GND
EN
EN
IN
PART NUMBERING INFORMATION
PIN DESCRIPTIONS
0.4V), the regulator’s series pass transistor is forced into a high impedance
5-pin SOT23
Top View
1
2
3
CM3102-12ST
Ordering Part
OUT
Number
remains above 97% of its nominal value for 1 to 5ms.
Standard Finish
5
4
1
L Fax: 408.263.7846
OUT
PG
Part Marking
) is applied to the output to quickly reduce the out-
BA12
EN
≥ 1.6V), the regulator is enabled. When EN
CM3102-12SO
Ordering Part
L
Number
www.calmicro.com
Lead-free Finish
1
Part Marking
CM3102
BB12
01/20/04

Related parts for CM3102-12SO