CM2009-05CP ONSEMI [ON Semiconductor], CM2009-05CP Datasheet - Page 3
![no-image](/images/no-image-200.jpg)
CM2009-05CP
Manufacturer Part Number
CM2009-05CP
Description
VGA or DVI-I Port Companion Circuit
Manufacturer
ONSEMI [ON Semiconductor]
Datasheet
1.CM2009-05CP.pdf
(8 pages)
CM2009-05CP
Ordering Information
LEAD(s)
A1
A2
A3
A4
A5
B1
B2
B3
B4
C1
C2
C3
C4
C5
Note 1: Can also be connected to the VGA connector side if used for a source device.
Note 2: Can also be used to connect to the Video Chip Sync Logic if it is used for a source device.
Note 1: Parts are shipped in Tape and Reel form.
Bumps
SYNC_OUT1
SYNC_OUT2
DDC_OUT1
DDC_OUT2
14
SYNC_IN1
SYNC_IN2
DDC_IN1
DDC_IN2
VIDEO_1
VIDEO_2
VIDEO_3
LV_EN
NAME
GND
V
CC
DESCRIPTION
Ground reference supply pin.
Video signal ESD protection channel. This pin is typically tied one of the video lines between the
controller device and the video connector.
Video signal ESD protection channel. This pin is typically tied one of the video lines between the
controller device and the video connector.
Video signal ESD protection channel. This pin is typically tied one of the video lines between the
controller device and the video connector.
This is a supply input for the SYNC_1 and SYNC_2 level shifters, video protection and the DDC
circuits.
DDC signal output. Connects to the DDC logic.
DDC signal output. Connects to the DDC logic.
Sync signal buffer output. Connects to the monitor Sync logic.
Sync signal buffer output. Connects to the monitor Sync logic.
DDC signal input. Connects to the video connector side of one of the DDC lines.
DDC signal input. Connects to the video connector side of one of the DDC lines.
Disables the Sync buffer outputs when low.
Sync signal buffer input. Connects to the video connector side of one of the Sync lines.
Sync signal buffer input. Connects to the video connector side of one of the Sync lines.
PART NUMBERING INFORMATION
Rev. P2 | Page 3 of 8 | www.onsemi.com
PIN DESCRIPTIONS
Package
CSP
Ordering Part Number
CM2009-05CP
1
1
1
Part Marking
TJ
2
2