vi-982419 Vicor Corporation, vi-982419 Datasheet - Page 6

• Manufacturer Part Number: vi-982419
• Description: 24vin 2vout 160watts Dc-dc Converter Module
• Manufacturer: Vicor Corporation

Vicor Corp. Tel: [phone] Fax: [phone]
Figure 9—DC coupled single-wire interface.
Figure 11—N+1 module array output connections.
PIN STYLES
CONTROL FUNCTIONS - PR PIN
Parallel Operation
The PR pin supports paralleling for increased power with N+1
(N+M) redundancy and phased array capability. Modules of
the same input voltage, output voltage, and power level will
current share if all PR pins are suitably interfaced.
Compatible interface architectures include the following:
DC coupled single-wire interface. All PR pins are directly
connected to one another. This interface supports current
Module 1
Module 2
Module N+1
Description
Short solder
Long solder
Short ModuMate
Long ModuMate
+Out
–Out
+Out
–Out
+Out
–Out
SC
SC
SC
+S
+S
+S
–S
–S
–S
Ground plane
+S
–S
+S
–S
Load
Set your site on VICOR at www.vicorpower.com
–S
+S
Notes
Requires in-board, mounting
On-board mounting for 0.65" boards
SurfMate or in-board socket mounting
On-board socket mounting
+In
PC
PR
–In
+In
PC
PR
–In
Module 1
Module 2
(up to 12)
• The +Out and –Out power buses should be
• The +Sense pins should be tied to the same
• At the discretion of the power system designer,
• OR’ing diodes may be inserted in series with
designed to minimize and balance parasitic
impedance from each module output to the load.
point on the +Out power bus; the –Sense pins
should be tied to the same point on the –Out
power bus.
a subset of all modules within an array may be
configured as slaves by shorting SC to –S.
the +Out pins of each module to provide
module output fault tolerance.
24Vin/2Vout/160W DC-DC Converter
Figure 10—AC coupled single-wire interface.
sharing but is not fault tolerant. Minus In pins must be tied to
the same electric potential. See Figure 9.
AC coupled single-wire interface. All PR pins are connected
to a single communication bus through 0.001µF (500V)
capacitors. This interface supports current sharing and is fault
tolerant except for the communication bus. See Figure 10.
Ground plane
Figure 12—OR’ing diodes connections.
0.001µF
0.001µF
+Out
–Out
SC
+S
–S
+In
PC
PR
–In
+In
PC
PR
–In
Module 1
Module 2
(up to 12)
other modules
+Sense from
in the array
Rev. 5.2
Page 6 of 9