NJU26125VC2 NJRC [New Japan Radio], NJU26125VC2 Datasheet - Page 7

• Manufacturer Part Number: NJU26125VC2
• Description: Seat Positioning Surround Decoder
• Manufacturer: NJRC [New Japan Radio]

1. Power Supply, Input/Output terminal, Clock, Reset
Ver.2010-07-01
1.1 Power Supply
1.2 Input/Output terminal
1.3 Clock
The NJU26125 has a power supply V
should be implemented at the all power supply terminals.
The NJU26125 include a built-in power supply (LDO) for internal logic. A built-in power supply generates
1.8V (-10% to +10%). VREGO (No.12) pin is a built-in power supply bypass pin. Connect low-ESR
capacitor of 4.7uF and 0.01uF in parallel between VSS (No.11) pin.
A built-in power supply is used only for NJU26125 operation. Be not short-circuited of this pin. Do not take
out the current, and connect other power supplies.
It restricts, when the input terminals (AD1, PROC, RESETb, SDI0, SDI1, SDI2, STBYb, SLAVEb, SCL,
TEST pins), the input/output terminals (LR, BCK, MCK pins) and the bi-directional Open-drain terminal
(SDA pin) of NJU26125, and V
tolerant.
The NJU26125 CLK pin requires the system clock that should be related to the sample frequency 256 Fs.
(For example : Fs=48kHz CLK=12.288MHz )
It is possible to be generated the system clock by connecting a crystal oscillator between CLK and
CLKOUT. CLK/CLKOUT pins are not 5V tolerant, so check the voltage level of these pins.
When SLAVEb pin is fixed on Low level, NJU26125 supplies the system clock from MCK pin. Fix the clock
input pin not used to Low level because either the CLK pin or the MCK pin is supplied in NJU26125.
The frequency divider for Master mode matched to the clock 256 times of Fs is installed in NJU26125.
When clock except 256 times of Fs is used by Master mode, be careful to use because a dividing
frequency of Master mode changes. Please check enough and decide parameter.
DD
are supplied on regular voltage (V
DD
. To setup good power supply condition, the decoupling capacitors
DD
=3.3V), and it becomes +5V Input
NJU26125
- 7 -