TS12001 TOUCHSTONE [Touchstone Semiconductor Inc], TS12001 Datasheet - Page 4

• Manufacturer Part Number: TS12001
• Description: A 0.65V/1?A Nanopower Voltage Detector with Dual Outputs
• Manufacturer: TOUCHSTONE [Touchstone Semiconductor Inc]

TS12001
PIN FUNCTIONS
Page 4
PIN
EP
10
1
2
3
4
5
6
7
8
9
COUTOD
COUTPP
REFOUT
NAME
OVDD
SET
VSS
VIN
NC
NC
----
ET
FUNCTION
Positive Supply Voltage. Connect a 0.1µF bypass capacitor from
this pin to analog VSS/GND.
External UVLO Trip Threshold Set Pin. When this pin is set to
VSS, the internal preset 0.78V UVLO trip threshold controls the
comparator output. When the applied voltage to this pin is higher
than 90mV, the SET pin sets the trip threshold and controls the
comparator output. If the SET pin is not used, connect the pin to
to VSS.
No Connection
Negative Supply Voltage.
Latch Enable Pin. When
comparator will toggle normally based on the inputs to the
comparator. When
COUTPP will remain HIGH despite any changes to the input of
the comparator. COUTPP will once again respond to changes to
the input when
LOW and the
LOW-to-HIGH transition occurs on COUTPP, COUTPP will
switch to HIGH and stay HIGH and not respond to any changes
at the input. The
For unlatched comparator operation, set
open-drain output (COUTOD) is the inverted version of the
COUTPP output.
0.58V Reference Output
No Connection
Comparator Open-Drain Output
Comparator Push-Pull Output
Output Driver Positive Supply Voltage. Connect a 0.1µF bypass
capacitor from this pin to analog VSS/GND.
Exposed paddle is electrically connected to VSS/GND.
ET is then LOW, COUTPP will stay LOW. If a
ET is toggled HIGH. If COUTPP is initially
ET pin must always be set to a known state.
ET is set LOW and COUTPP is HIGH,
ET is set HIGH, the outputs of the
ET to HIGH. The
TS12001DS r1p0
RTFDS