SDA9489X ETC [List of Unclassifed Manufacturers], SDA9489X Datasheet - Page 11

no-image

SDA9489X

Manufacturer Part Number
SDA9489X
Description
PIP IV Advanced SOPHISTICUS High-End Picture-In-Picture ICs
Manufacturer
ETC [List of Unclassifed Manufacturers]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
SDA9489X
Manufacturer:
MICRONR
Quantity:
5 510
Part Number:
SDA9489X
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
Part Number:
SDA9489X B31
Manufacturer:
SUN
Quantity:
38
Part Number:
SDA9489X B31
Manufacturer:
MICRONAS
Quantity:
1 000
Part Number:
SDA9489X B31
Manufacturer:
MICRONAS
Quantity:
20 000
Part Number:
SDA9489X GEG
Manufacturer:
MICRONAS
Quantity:
592
Part Number:
SDA9489X-B31
Manufacturer:
MICRONAS
Quantity:
381
Part Number:
SDA9489X-B31
Manufacturer:
MICRONAS
Quantity:
20 000
Part Number:
SDA9489XB31
Manufacturer:
Micronas
Quantity:
209
SDA 9489X
SDA 9589X
The clamping pulse can be shifted in position (CLMPIST) and length (CLMPID) to adjust
to the specific application. The ADCs are driven by a 20.25 MHz free running crystal
clock which is not related to the incoming CVBS signal.
To avoid aliasing by subsampling the CVBS signal and the Y/C signals should be band-
limited to 10MHz. In the same manner the U/V signal frequency spectrum should not
exceed 5 MHz. The digital filtering suppresses all frequencies above the usable
spectrum.
4.1.3
To accommodate to different CVBS input voltages an automatic gain control has been
implemented. The chip works correctly for input voltages in the range from 0.5 to 1.5V
For best signal-to-noise ratio, the maximum CVBS amplitude is recommended if
available. The AGC behavior can be chosen out of four possibilities (AGCMDE).
The sync height serves as reference for the gain control in the typical application. When
using overflow detection only, the gain is set to maximum and is reduced whenever an
overflow occurs. This procedure will be executed again when a channel change is
detected or the gain control is manually reset by AGCRES.
Figure 4-2
4.1.4
The nominal CVBS signal with 75% color has a magnitude of 1 V
is left to permit signals with 100% color resulting in 1.23 V
contain the sync part. Its levels correspond to the CVBS levels except for the missing
color and burst. After A/D conversion the video part is clamped to its black value and is
amplified to 224 digital steps. The nominal signal levels ensure correct brightness and
saturation. The YUV signal levels conform to the ITU 601 recommendation.
Micronas
Automatic Gain Control
Signal Magnitudes
AGC characteristic
1.5
0.5
2
1
0
0
2
4
Automatic Gain Control Characteristic
6
AGCVAL
8
10
pp
12
. The Y signal must always
pp
Preliminary Data Sheet
. The upper headroom
14
System Description
16
4-11
pp
.

Related parts for SDA9489X