cxa2050s Sony Electronics, cxa2050s Datasheet - Page 42

• Manufacturer Part Number: cxa2050s
• Description: Y/c/rgb/d For Pal/ntsc Color Tvs
• Manufacturer: Sony Electronics

4. Notes on operation
Because the RGB signals and deflection signals output from the CXA2050S are DC direct connected, the
board pattern must be designed consideration given to minimizing interference from around the power supply
and GND.
Do not separate the GND patterns for each pin; a solid earth is ideal. Design power supply as low impedance
as possible. when impedance of power supply is high, video block power supply V
block power supply DV
to each SV
power supply side of the by-pass capacitor which is inserted between the power supply and GND as near to
the pin as possible. Also, locate the XTAL oscillator, ceramic oscillator and IREF resistor as near to the pin as
possible, and do not wire signal lines near this pin. Drive the Y, external Y/color difference and external RGB
signals at a sufficiently low impedance, as these signals are clamped when they are input using the capacitor
connected to the input pin.
DC bias is applied to the chroma signal within the IC. Input the chroma signal with low impedance via an
external capacitor.
Use a resistor (such as a metal film resistor) with an error of less than 1% for the IREF pin.
Use a capacitor, such as an MPS (metalized polyester capacitor) with a small tan for SAWOSC.
When using a line frequency FH of 15625Hz for the main clock (PAL-B, G, etc.), Murata's Ceralock
CSB500F63 is recommended. This will yield a free-running frequency in the neighborhood of 15625Hz.
CC
and DV
CC
CC
, and its deflection operation may be unstable. For this countermeasure, inputting LC
stabilizes the operation because power supply's interference is reduced. Locate the
– 42 –
CC
interferes with deflection
CXA2050S