DF4-2P-2C_1 HIROSE [Hirose Electric], DF4-2P-2C_1 Datasheet - Page 5

• Manufacturer Part Number: DF4-2P-2C_1
• Description: 2mm Pitch Connector Directly Mounted on Board
• Manufacturer: HIROSE [Hirose Electric]

B206
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
DF4 Series●2mm Pitch Connector Directly Mounted on Board
BPrecautions
1. Recommended
1.
2. Cleaning Condition
3. Connection Condition
Soldering Condition
Flow: 250ç for 3 seconds
Manual soldering: 290±10ç for 2 seconds
■ If the cable neighboring the connector is bent and unstraightened, secure a large bending radius because the
■ After the soldering process. If a stress is applied to the cable in the state where the connector and the
Refer to Nylon Connector Use Hand book.
Don't use a solvent such ass trichloroethylene which invades the cable Jacket. In addition, avoid heat
cleaning by a solvent.
Refer to the Nylon Connector Use Hand book.
Jacket will be broken by the solder heat and the contact wire will be exposed.The Jacket in this part will be tore.
cable has heat inside, the Jacket hold area will be loosen. Therefore, carry out the post-soldering
operation after the connector has returned to the room temperature..