ATSAM2195 ATMEL [ATMEL Corporation], ATSAM2195 Datasheet - Page 13

• Manufacturer Part Number: ATSAM2195
• Description: Audio Processing
• Manufacturer: ATMEL [ATMEL Corporation]

7. Reset and Power Down
7.1
6308A–DRMSD–10-May-07
3.3V Single Supply Application
During power-up, the RESET input should be held low until the crystal oscillator and PLL are
stabilized, which can take about 20 ms. A typical RC/diode power-up network can be used.
After RESET, the ATSAM2195 enters an initialization routine. It takes around 50 ms before a
MIDI IN or MPU message can be processed.
Audio begins after 500 ms, maximum.
To enter power-down, Reset should be held low 500 ms min and then PDWN asserted low.
In Power-down mode, the crystal oscillator and PLL are stopped. The chip enters a deep power
down sleep mode.
To exit power down, PDWN has to be asserted high, then RESET applied.
Power down mode is managed by the internal regulator. The equivalent schematic and standard
connection is shown on the diagram below.
ATSAM2195
ATSAM2195
13