SS8014G SSC [Silicon Standard Corp.], SS8014G Datasheet - Page 5

• Manufacturer Part Number: SS8014G
• Description: 150mA Low-Noise LDO Regulator
• Manufacturer: SSC [Silicon Standard Corp.]

1/12/2005 Rev.2.11
Layout Guide
An input capacitance of ~1µF is required between the
SS8014 input pin and ground (the amount of the capac i-
tanc e may be increased without limit), This capacitor
must be located a distance of not more than 1cm from
the input and return to a clean analog ground.
This input capacitor filters out the input voltage spike
caused by the surge current due to the inductive effect
of the package pin and the printed circuit board’s rout-
*Distance between pin & capacitor must be no more than 1cm
www.SiliconStandard.com
Figure 3. Suggested PCB Layout
ing wire. Otherwise, the actual voltage at the IN pin
may exceed the absolute maximum rating.
The output capacitor also must be located a distance
of not more than 1cm from output to a clean analog
ground. This capacitor filters out the output spike
caused by the surge current due to the inductive effect
of the package pin and the printed circuit board’s rout-
ing wire. Figure 3 is the suggested PCB layout of SS8014.
SS8014G
5 of 6