lxt351 Intel Corporation, lxt351 Datasheet - Page 14

• Manufacturer Part Number: lxt351
• Description: T1/e1 Short Haul Transceiver With Crystal-less Jitter Attenuation
• Manufacturer: Intel Corporation

LXT351 — T1/E1 Short Haul Transceiver with Crystal-less Jitter Attenuation
2.2.2
2.2.3
2.2.4
2.2.5
14
Figure 3. 50% Duty Cycle Coding
Transmit Monitoring
The transmitter includes a short circuit limiter that limits the current sourced into a low impedance
load. The limiter automatically resets when the load current drops below the limit. The current is
determined by the interface circuitry (total resistance on transmit side).
The Performance Status Register (PSR) flags open circuits in bit PSR.DFMO. A transition of
DFMO can provide an interrupt, and its transition sets bit TSR.DFMO = 1. Writing a 1 in bit
ICR.CDFMO clears the interrupt; leaving a 1 in the bit masks that interrupt.
Transmit Drivers
The transceiver transmits data as a 50% line code as shown in
consumption, the line driver is active only during transmission of marks, and is disabled during
transmission of spaces. Biasing of the transmit DC level is on-chip.
Transmit Idle Mode
Transmit Idle mode allows multiple transceivers to be connected to a single line for redundant
applications. When TCLK is not present, Transmit Idle mode becomes active, and TTIP and
TRING change to the high impedance state. Remote or Dual Loopback, TAOS or any internal
transmit patterns temporarily disable the high impedance state.
Transmit Pulse Shape
As shown in
EC3 of Control Register #1 (CR1).
The transceiver produces DSX-1 pulses for short-haul T1 applications (settings from 0 dB to +6.0
dB of cable) or G.703 pulses for E1 applications. Shaped pulses are applied to the AMI line driver
for transmission onto the line at TTIP and TRING. Refer to the Test Specifications section for
pulse mask specifications.
Table 8 on page
25, the transmitted pulse shape is established by bits EC1 through
Bit Cell
1
0
Figure
1
3. To reduce power
Datasheet