sp5668 ETC-unknow, sp5668 Datasheet - Page 9

• Manufacturer Part Number: sp5668
• Description: 2.7ghz 3-wire Controlled Synthesiser
• Manufacturer: ETC-unknow

Loop Bandwidth
intended require a loop filter bandwidth of between 2kHz and
10kHz.
1kHz and10kHz offset. It is common practice to arrange the
loop filter bandwidth such that the 1kHz figure lies within the
loop bandwidth. Thus the phase noise depends on the
synthesiser comparator noise floor, rather than the VCO.
providing the loop is designed correctly, and is not
underdamped.
The majority of applications for which the SP5668 is
Typically the VCO phase noise will be specified at both
The 10kHz offset figure should depend on the VCO
Reference Source
when operated with a large step size. This is due to the fact
that the LO phase noise within the loop bandwidth is:
phase comparator
noise floor
irrespective of sampling frequency, this means that the best
performance will be achieved when the overall LO to phase
comparator division ratio is a minimum.
comparator sampling frequency:–
A) reduce the division ratio between the reference source
and the phase comparator
B) use a higher reference source frequency.
Approach B) may be preferred for best performance since it is
possible that the noise floor of the reference oscillator may
degrade the phase comparator performance if the reference
division ratio is very small.
The SP5668 offers optimal LO phase noise performance
Assuming the phase comparator noise floor is flat
There are two ways of achieving a higher phase
+ 20 log
(
phase comparator frequency
LO frequency
SP5668
)
9