ax88190 ASIX Electronics Corporation, ax88190 Datasheet - Page 14

no-image

ax88190

Manufacturer Part Number
ax88190
Description
Pcmcia 10/100m Fast Ethernet Mac Controller
Manufacturer
ASIX Electronics Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ax88190AL
Manufacturer:
TOSHIBA
Quantity:
1 001
Part Number:
ax88190AL
Manufacturer:
ASLX
Quantity:
1 000
Part Number:
ax88190AL
Manufacturer:
ASLX
Quantity:
20 000
Part Number:
ax88190P
Manufacturer:
ASIX
Quantity:
1 122
Part Number:
ax88190P
Manufacturer:
ASIX
Quantity:
20 000
4.1.1 Configuration Option Register of LAN (LCOR) Offset 3C0H (Read/Write)
FIELD
5:0
7
6
AX88190
R/W/C
R/W
R/W
R/W
Software Reset
Level IRQ
Function Configuration Index
Assert this bit will reset the LAN function of AX88190. Return a 0 to this bit will leave the
LAN function of AX88190 in a post-reset state as same as that following a hardware reset.
The value of this bit is 0 at power-on.
This bit should be set to 1, the AX88190 always generates Level Mode Interrupt.
These six bits are used to indicate entry of the card configuration table locate in the CIS.
The default value is 0
.
On multifunction PC Card,
Bit 5, Bit 4 : MODEM I/O base registers
Bit 5
Bit 3 : Enable Power Down mode
Bit 2 : Enable IREQ# Routing
Bit 1 : Enable Base and Limit Registers
Bit 0 : Enable Function
If bit 0 of LCOR is set to 0, this bit is ignored.
If bit 0 of LCOR is set to 1 and this bit is set to 1, the LAN will go into power down
mode. At power down mode AX88190 will disable MAC transmitting and receiving
operation. But the host interface will not be affected.
If bit 0 of LCOR is set to 0, this bit is ignored.
If bit 0 of LCOR is set to 1 and this bit is set to 1, the LAN will generate interrupt request
via IREQ# signal. If this bit is set to 0, the LAN will not generate interrupt request via
IREQ# line.
If bit 0 of LCOR is set to 0, this bit is ignored.
If bit 0 of LCOR is set to 1 and this bit is set to 1,only I/O addresses that are qualified by
the Base and Limit registers are passed to LAN function. If this bit is set to 0,all I/O
addresses are passed to LAN function.
If this bit is set to 0, the LAN function is disabled.
If this bit is set to 1, the LAN function is enabled.
0
0
1
1
Bit 4
0
1
0
1
PCMCIA Fast Ethernet MAC Controller
MODEM I/O base
Decided by MIOBASE registers ( See section 4.2.3 )
2f8H
3e8H
2e8H
14
DESCRIPTION
ASIX ELECTRONICS CORPORATION

Related parts for ax88190