ld7575a Leadtrend Technology, ld7575a Datasheet - Page 9

• Manufacturer Part Number: ld7575a
• Description: Green-mode Pwm Controller With High-voltage Start-up Circuit
• Manufacturer: Leadtrend Technology

Current Sensing, Leading-edge Blanking and
the Negative Spike on CS Pin
The typical current mode PWM controller feedbacks both
current signal and voltage signal to close the control loop
and achieve regulation. The LD7575A detects the primary
MOSFET current from the CS pin, which is not only for the
peak current mode control but also for the pulse-by-pulse
current limit. The maximum voltage threshold of the current
sensing pin is set as 0.85V. Thus the MOSFET peak current
can be calculated as:
A 200nS leading-edge blanking (LEB) time is included in the
input of CS pin to prevent the false-trigger caused by the
current spike. In the low power application, if the total pulse
width of the turn-on spikes is less than 200nS and the
negative spike on the CS pin is not exceed -0.3V, the R-C
filter (as shown in figure15) can be eliminated.
However, the total pulse width of the turn-on spike is related
to the output power, circuit design and PCB layout. It is
strongly recommended to add the small R-C filter (as shown
in figure 16) for higher power application to avoid the CS pin
damaged by the negative turn-on spike.
Output Stage and Maximum Duty-Cycle
An output stage of a CMOS buffer, with typical 500mA
driving capability, is incorporated to drive a power MOSFET
directly.
limited to 75% to avoid the transformer saturation.
Voltage Feedback Loop
The voltage feedback signal is provided from the TL431 in
the secondary side through the photo-coupler to the COMP
pin of LD7575A.
UC384X, is with 2 diodes voltage offset then feeding into the
voltage divider with 1/3 ratio, that is,
A pull-high resistor is embedded internally thus can be
eliminated on the external circuit.
Leadtrend Technology Corporation
LD7575A-DS-00a November 2007
V
+
And the maximum duty-cycle of LD7575A is
(
PWM
COMPARATOR
I
The input stage of LD7575A, like the
PEAK
(
MAX
)
)
=
=
1
3
. 0
×
R
85
(
S
V
V
COMP
www.leadtrend.com.tw
−
2
V
F
)
9
LD7575A
VCC
GND
OUT
CS
Fig. 15
Fig. 16
Can be removed if the negative
spike is not over spec. (-0.3V).
LD7575A
200ns
blanking
time