STV-366-R01 STMICROELECTRONICS [STMicroelectronics], STV-366-R01 Datasheet - Page 17

• Manufacturer Part Number: STV-366-R01
• Description: 1.8V optical mouse sensor
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

VT5366
5.5
5.6
5.7
Note:
Operating mode
The VT5366 itself has only two operating modes; ON - when PowerDown = 0 and OFF -
when PowerDown = 1
Overall system behavior is controlled by the external microprocessor which can switch the
VT5366 on and off with various duty cycles. Typical operation is described below.
1.
2.
3.
4.
5.
Motion sensitivity in non RUN modes
Before going into a non-run mode write 0x40 to register 0x2F (ie. when the mouse goes into
idle mode), this will make the motion engine more sensitive to frame change at lower non-
run frame rates on low contrast surfaces.
When waking up (on motion detect) re-write the default 0x10 to register 0x2F to maintain
running motion accuracy.
Overall system performance
The overall performance of a wireless mouse system depends on many different factors
including:
See Applications Note AN2473 for details on Optical Wireless Mouse Design using the
VT5366.
The processor enables the VT5366 by setting PowerDown (pin 23) LOW.
The processor delays for T
The processor then monitors Motion Detect to see if motion has occurred. If Motion
Detect (pin 24) = 0 then no motion has been detected and the VT5366 can be put back
to sleep by setting PowerDown HIGH.
The processor then waits for a time T
If motion IS detected at step (3) i.e. Motion Detect = 1 then the motion vectors are read
over the I2C interface. The processor can then monitor Motion Detect again to see if
further motion has occurred.
–
–
–
–
–
–
Battery choice
Power supply design
Choice of external microprocessor
Design of firmware running in external processor
Design of external RF transmission circuitry
User model i.e. how much time the mouse is actually being used and surface type.
on
(typically 250µs) to allow some frames to be captured.
sleep
and returns to step (1).
Operation
17/30