mk-1-0180 Reed Relays and Electronics, mk-1-0180 Datasheet

no-image

mk-1-0180

Manufacturer Part Number
mk-1-0180
Description
Mk Reed Sensor With Integrated Resistor
Manufacturer
Reed Relays and Electronics
Datasheet
Due to continual improvement, specifications are subject to change without notice
Reed Relays and Electronics India Limited  info@reed-switch.com  Tel 91-44-6528-4022
This reed sensor is suitable for use in the following applications and many others: fluid level sensing,
contact protection, resistance matrixes...
MK-(Resistor
Resistor value in ordering code refers to standard integrated resistor (1/8 W, 1% tolerance)
MK-1-0180 denotes 10-15 operate AT with an integrated 180resistor.
Contact Form
Contact Rating (max)
Switching Current (max)
Carry Current (max)
Switching Voltage (max)
Breakdown Voltage (min)
Initial Contact Resistance (max)
Operating Temperature
Shock Resistance (½Sin wave for 11ms)
Vibration Resistance (10-2000Hz)
Does not require power for operation
Normally open (NO) form A contact
Omni-polar device; actuates with either pole of magnet
Various wattages and resistor values
Ideal for level sensing applications
Lead (Pb) free and RoHS compliant
Applications
Specification
Ordering Code
Example
OAT Code
1
2
Value)-(Operate AT
MK Reed Sensor with integrated resistor
Molded with internal blades perpendicular to dot marked surface
10 – 15
15 – 20
2.54 mm pitch SIP Package
Code)
www.reed-sensor.com
25 December 2006
All dimensions in mm
W / VA
m
V
V
°C
A
A
g
g
DC
DC
-40 to +140
0.75
100
150
150
0.5
10
30
20
A

Related parts for mk-1-0180

mk-1-0180 Summary of contents

Page 1

... Resistor value in ordering code refers to standard integrated resistor (1 tolerance) Example MK-1-0180 denotes 10-15 operate AT with an integrated 180resistor. Due to continual improvement, specifications are subject to change without notice Reed Relays and Electronics India Limited  info@reed-switch.com  Tel 91-44-6528-4022 All dimensions in mm ...

Page 2

... MK Reed Sensor with integrated resistor Operate and release distances for the MK-xxxx reed sensor in the two standard AT bands when actuated (as shown in the sketches) with NdFeB standard magnets is shown below. All distances given are in mm with tolerances of ±0.5mm. Distances given will vary if the reed sensor leads are cropped after soldering. Although some of the AT band / magnet combinations will produce similar actuating distances, selecting the right AT band and magnet for an application is important and can be done by going through our AT band FAQ and our magnet selection guide ...

Related keywords