IL33197AD IKSEMICON [IK Semicon Co., Ltd], IL33197AD Datasheet

Page 1

... Integrated Relay Driver With Free Wheeling Protection Diode • Operating Voltage Range From 8 • For Front Wiper and Rear Wiper Window Applications TECHNICAL DATA IL33197A ORDERING INFORMATION IL33197AN DIP IL33197AN-01 DIP IL33197AD SOIC IL33197AD-01 SOIC T = -45° to 105°C (SOIC -45° to 125°C (DIP ...

Page 2

ELECTRICAL CHARACTERISTICS (–45° values reflect approximate mean 25°C with VCC = the time of initial device characterization.) NOTES: 1. The oscillator frequency is defined by the current flowing through the external resistor ...

Page 3

Figure 1. Intermittent Wash Wiper Typical Application This application shows the IL33197A with the external wirings and two speed wiper motor. This application has the Intermittent and Wash Wiper functions. INTRODUCTION The IL33197A is a wiper timer control device designed ...

Page 4

Conditions: ● disconnected. ● C ONT disconnected or connected to ground. In this condition, the circuit will respond to the switching of W/W to Vbb after a time T1 (see T1 Debounce Timing). If W/W is disconnected or ...

Page 5

Figure 4. Switching Waveform W/W and INT Active The criteria for an input signal to be detected is that it should be active at two successive negative internal clock edges. The inputs are sampled on the negative edge of the ...

Page 6

Recommended External Component Values Below are the recommended component values to ensure the device will operate properly, and that all specified parameters will stay within their tolerances. R1 should be greater than 100Ω; recommended value of 220Ω. R1 can be ...

Page 7

-T- SEATING PLANE 0.25 (0.010 NOTES: 1. Dimensions “A”, “B” do not include mold flash or protrusions. Maximum mold flash or protrusions 0.25 mm (0.010) per ...