NIPCI-6030E NI [National Instruments Corporation], NIPCI-6030E Datasheet - Page 9

• Manufacturer Part Number: NIPCI-6030E
• Description: Full-Featured E Series Multifunction DAQ 12 or 16-Bit, up to 1.25 MS/s, up to 64 Analog Inputs
• Manufacturer: NI [National Instruments Corporation]

RTSI Bus (PCI and FireWire only)
Trigger lines
PXI Trigger Bus (PXI only)
Trigger lines...................................................... 6
Star trigger ....................................................... 1
Bus Interface
PCI, PXI, FireWire (DAQPad)............................. Master, slave
USB (DAQPad) .................................................. Slave
PCMCIA (DAQCard) .......................................... Slave
Power Requirements
Discharge time with BP-1 battery pack
FireWire (DAQPad) ........................................... 2.5 hours, typical
USB (DAQPad) .................................................. 3 hours, typical
Physical
Dimensions (Not Including Connectors)
PCI ................................................................... 17.5 by 10.7 cm (6.9 by 4.2 in.)
PXI ................................................................... 16.0 by 10.0 cm (6.3 by 3.9 in.)
Specifications – NI 607xE, NI 606xE, NI 6040E, NI 602xE
Device
PCI-607xE, PXI-607xE
6040E
DAQCard-6062E
DAQCard-6024E
6023E, 6025E,
PCI-6024E
Device
DAQPad-6020E
DAQPad-6070E
PCI ............................................................ 7
FireWire (DAQPad) .................................... 4
*Excludes power consumed through I/O connector
1
2
15 W, +9 to +30 VDC
17 W, +9 to +25 VDC
340 mA typical
750 mA maximum
270 mA typical
750 mA maximum
+5 VDC (±5%)*
Power*
1.1 A
1.0 A
0.7 A
2
Power Available at I/O Connector
Power Available at I/O Connector
+4.65 to +5.25 VDC, 1 A
+4.65 to +5.25 VDC, 1 A
+4.65 to +5.25 VDC, 1 A
+4.65 to +5.25 VDC, 1 A
+4.65 to +5.25 VDC, 250 mA
+4.65 to +5.25 VDC, 250 mA
+4.65 to +5.25 VDC, 1 A
12-Bit E Series Multifunction
National Instruments • Tel: [phone] • Fax: [phone] • [e-mail] • ni.com
DAQPad (30 cm enclosure)............................... 25.4 by 30.7 by 4.3 cm
DAQPad (15 cm enclosure)............................... 14.6 by 21.3 by 3.8 cm
DAQCard........................................................... Type II PC Card
Environment
Operating temperature..................................... 0 to 55 °C
Storage temperature ........................................ -20 to 70 °C
Relative humidity ............................................. 10 to 90%, noncondensing
Certifications and Compliances
CE Mark Compliance
1
2
Refer to RTSI specifications for available RTSI trigger lines. RTSI not available on DAQCards.
See page 134 for RT Series devices, power requirements and physical parameters.
6070E
6040E
6020E
6023E
PCI-6024E
DAQCard-6062E,
DAQCard-6024E
6071E
6025E
(continued)
DAQ Specifications
I/O Connector
100-pin female 0.050 D-type
68-pin male 0.050 D-type
68-pin female VHDCI
(10 by 12.1 by 1.7 in.)
(5.8 by 8.4 by 1.5 in.)
0 to 40 °C for DAQCard-6062E and DAQCard-6024E with
a maximum internal temperature of 70 °C as measured by
onboard temperature sensor; case temperature should not
exceed 55 °C for any DAQCard
237