TDC_WPN30R CANDD [C&D Technologies], TDC_WPN30R Datasheet - Page 4

• Manufacturer Part Number: TDC_WPN30R
• Description: 30 Watt Single Output Half Brick DC/DC Converter
• Manufacturer: CANDD [C&D Technologies]

Any data, prices, descriptions or specifications presented herein are subject to revision by C&D Technologies, Inc. without notice. While such information is believed to
be accurate as indicated herein, C&D Technologies, Inc. makes no warranty and hereby disclaims all warranties, express or implied, with regard to the accuracy or
completeness of such information. Further, because the product(s) featured herein may be used under conditions beyond its control, C&D Technologies, Inc. hereby
disclaims all warranties, either express or implied, concerning the fitness or suitability of such product(s) for any particular use or in any specific application or arising
from any course of dealing or usage of trade. The user is solely responsible for determining the suitability of the product(s) featured herein for user’s intended purpose
and in user’s specific application. C&D Technologies, Inc. does not warrant or recommend that any of its products be used in any life support or aviation or aerospace
applications.
Device Family
Model Number
Remote On/Off Logic
Product: www.cdpowerelectronics.com
SINGLE
BOTTOM
VIEW
Indicated 30 Watt Regulated DC/DC Converter
Positive Logic - No Number
Negative Logic - 1
Selected from Table of Electrical Characteristics
Where:
TOP
VIEW
xx = Input Voltage
zz = Output Voltage
y = Number of Outputs (Single “S”)
3400 E Britannia Drive, Tucson, Arizona 85706
Power Electronics Division, United States
Tel: [phone] Fax: [phone]
ORDERING INFORMATION
WPN30Rxxyzz
WPN30R
xxyzz -
MECHANICAL
WPN30R REV A 6/02
SIDE
VIEW
Tel: [phone] Fax: [phone]
Milton Keynes MK14 5BU UK
C&D Technologies, (NCL)
NOTES
All dimensions are in inches (millimeters).
Unless stated otherwise, dimensional
tolerance + 0.010” (+0.2mm).
Pin placement tolerance: +0.015” (+0.2mm).
Marked with specific model ordered, date,
code, job code.
MATERIAL: Lead material is brass with a
solder plated surface to allow ease of
solderability.
4