AP105-RP34L-SC1-212 Hirose Electric, AP105-RP34L-SC1-212 Datasheet - Page 6

• Manufacturer Part Number: AP105-RP34L-SC1-212
• Description: Low Profile Connectors for AC power supply
• Manufacturer: Hirose Electric

6
Straight Plug
Right Angle Plug
Assembly Instructions(3-Position Plug)
Outer case
Insulator body
Outer case
Outer case
Outer case
Outer case
Insulator body
1. Slide the bushing over the cable.
2. Prepare the cable end and the conductors as shown.
3. Crimp the contacts to each conductor.
4. Insert each of the contacts into the insulator body.
5. Crimp the cable clamp over the cable at designated
6. Place the outer case on a flat surface , with inside facing up.
7. Carefully place the insulator body, clamp and the bushing
Note A: When placing all components in the case,
Note B: All components should fit easily, without use of
8. Carefully align the other outer case over all
9. Snap the case in place.
1. The right angle plug can also be assembled by
Verify the crimp dimensions.
Verify that the contact is secure by slightly pulling
on the conductor. Should the contacts require re-
insertion, use the tool RP6-SC-TP to remove them
(Inserted from the termination side).
dimension (Tool number:RP34-TC-01).
into corresponding indents and cut-outs in the outer case.
Verify correct location. (As shown on drawing)
components case. Do not force alignment.
using the same procedure as the straight plug.
exercise caution as NOT to damage any of the
protruding snap.
any force.