TDA935x Philips, TDA935x Datasheet - Page 61

• Manufacturer Part Number: TDA935x
• Description: TV Signal Processor-Teletext Decoder with Embedded u-Controller
• Manufacturer: Philips

Philips Semiconductors
FUNCTIONAL DESCRIPTION OF VIDEO PROCESSOR
Vision IF amplifier
The vision IF amplifier can demodulate signals with
positive and negative modulation. The PLL demodulator is
completely alignment-free.
The VCO of the PLL circuit is internal and the frequency is
fixed to the required value by using the clock frequency of
the -Controller/Teletext decoder as a reference. The
setting of the various frequencies (38, 38.9, 45.75 and
58.75 MHz) can be made via the control bits IFA-IFC in
subaddress 27H. Because of the internal VCO the IF
circuit has a high immunity to EMC interferences.
QSS Sound circuit
The sound IF amplifier is similar to the vision IF amplifier
and has an external AGC decoupling capacitor.
The single reference QSS mixer is realised by a multiplier.
In this multiplier the SIF signal is converted to the
intercarrier frequency by mixing it with the regenerated
picture carrier from the VCO. The mixer output signal is
supplied to the output via a high-pass filter for attenuation
of the residual video signals. With this system a high
performance hi-fi stereo sound processing can be
achieved.
The AM sound demodulator is realised by a multiplier. The
modulated sound IF signal is multiplied in phase with the
limited SIF signal. The demodulator output signal is
supplied to the output via a low-pass filter for attenuation
of the carrier harmonics. The AM signal is supplied to the
output (AUDOUT/AMOUT) via the volume control.
Switching between the QSS output and AM output is made
by means of the AM bit in subaddress 29H (see also
Table 1).
2001 Jan 18
TV signal processor-Teletext decoder with
embedded -Controller
61
FM demodulator
The FM demodulator is realised as narrow-band PLL with
external loop filter, which provides the necessary
selectivity without using an external band-pass filter. To
obtain a good selectivity a linear phase detector and a
constant input signal amplitude are required. For this
reason the intercarrier signal is internally supplied to the
demodulator via a gain controlled amplifier and AGC
circuit. To improve the selectivity an internal bandpass
filter is connected in front of the PLL circuit.
The nominal frequency of the demodulator is tuned to the
required frequency (4.5/5.5/6.0/6.5 MHz) by means of a
calibration circuit which uses the clock frequency of the
to the wanted frequency is realised by means of the control
bits FMA/FMB in the control bit 29H.
From the output status bytes it can be read whether the
PLL frequency is inside or outside the window and whether
the PLL is in lock or not. With this information it is possible
to make an automatic search system for the incoming
sound frequency. This can be realised by means of a
software loop which switches the demodulator to the
various frequencies and then select the frequency on
which a lock condition has been found.
The deemphasis output signal amplitude is independent of
the TV standard and has the same value for a frequency
deviation of 25 kHz at the 4.5 MHz standard and for a
deviation of 50 Khz for the other standards.
-Controller/Teletext decoder as a reference. The setting
TDA935X/6X/8X PS/N2 series
Tentative Device Specification