MAX3265 MAXIM [Maxim Integrated Products], MAX3265 Datasheet - Page 13

• Manufacturer Part Number: MAX3265
• Description: 3.0V to 5.5V, 1.25Gbps/2.5Gbps Limiting Amplifiers
• Manufacturer: MAXIM [Maxim Integrated Products]

In an optical receiver, the electrical power change at
the limiting amplifier is 2x the optical power change.
As an example, if a receiver’s optical input power (x)
increases by a factor of two, and the preamplifier is lin-
ear, then the voltage input to the limiting amplifier also
increases by a factor of two.
The optical power change is 10log(2x / x) = 10log(2) =
+3dB.
At the limiting amplifier, the electrical power change is:
The MAX3264/MAX3265/MAX3268/MAX3269/MAX3765s’
typical voltage hysteresis is 4.4dB. This provides an opti-
cal hysteresis of 2.2dB.
In a GBIC application, the GBIC’s LOS output must be
high impedance when V
shows the recommended circuit to maintain high
impedance. ESD protection diodes on the MAX3264/
MAX3265/MAX3268/MAX3269/MAX3765/MAX3768
LOS outputs can be turned on when V
V
The standard PECL termination (50
recommended for best performance and output char-
acteristics (see Figure 1). The data outputs operate at
high speed and should always drive transmission lines
with matched, balanced terminations.
Figure 9 shows an alternate method for terminating the
data outputs. The technique provides approximately
8mA DC bias current, with a 45
put termination. This technique is useful for viewing the
output on an oscilloscope or changing the PECL refer-
ence voltage.
For high current density and reliable operation, the
MAX3264/MAX3265/MAX3268/MAX3269 use gold met-
alization. Make connections to the dice with gold wire
only, and use ballbonding techniques (wedge bonding
is not recommended). Die-pad size is 4-mils square,
with a 6-mil pitch. Die thickness is 15 mils (0.375mm).
10log
CC_
MODULE.
2V
V
IN
IN
2
2
/ R
/ R
IN
Applications Information
IN
______________________________________________________________________________________
10log(2 )
CC_
MODULE = GND. Figure 8
GBIC Loss of Signal
PECL Terminations
2
Optical Hysteresis
Wire Bonding Dice
+3.0V to +5.5V, 1.25Gbps/2.5Gbps
AC load, for the out-
20log(2)
to V
CC_
CC
HOST >
- 2V) is
6dB
Figure 8. Recommended GBIC LOS Circuit
Figure 9. Alternative PECL Termination
DRIVING 50
GBIC MODULE
MAX3264
MAX3265
MAX3268
MAX3269
MAX3765
MAX3768
MAX3268
MAX3269
MAX3768
Limiting Amplifiers
V
TO GROUND
CC_
OUT+
OUT-
MODULE
LOS
470
470
GENERAL-
PURPOSE
NPN
HOST
V
CC_
50
50
HOST
4.7k
13