PCF85116-3TD PHILIPS [NXP Semiconductors], PCF85116-3TD Datasheet - Page 8

• Manufacturer Part Number: PCF85116-3TD
• Description: I2C Demonstration Board 2005-1 Quick Start Guide
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
7. Starting Win-I2CUSB Lite
UM10206
User manual
Fig 4. Win-I2CUSB Lite main window
Board Self Test Routine
Hardware detection message
When you have correctly installed the software and the Demonstration Board Hardware is
connected and recognized by the computer, start the Win-I2CUSB Lite software (see
Figure
•
•
•
•
•
When the Demonstration Board hardware is correctly connected to the USB port and
the computer recognizes it, the message “Hardware Detected” is displayed.
Switched 3.3 V and 5.0 V power supplies are controlled through the “Options” menu
or by double clicking on the 3.3 V or 5.0 V symbols on the lower side of the main
window. Power supplies are disabled by default and you must enable them before
using the I
I
the frequency symbol in the lower side of the main window.
I
in the “Device” menu. You can only select I
are highlighted in the menu.
The Expert Mode selected through “Device
customized I
8 lines of command in the Lite version of the software. Each line of command can
have up to 9 bytes of data.
2
2
C-bus frequency is controlled through the “Options” menu or by double clicking on
C-bus devices on the board are controlled using the corresponding control window
4).
2
C-bus devices on the board.
2
C-bus commands to any device on the board. Expert Mode is limited to
Access to the Expert Mode that allows
writing specific I
Rev. 01 — 13 June 2006
Switched power
indicators
I2C Demonstration Board 2005-1 Quick Start Guide
2
C commands
2
C-bus devices which are on the board and
Universal Modes” allows you to send
Device selection
(devices not supported in Lite
version are dimmed)
I
2
C frequency
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
UM10206
8 of 12