SAB-C501G-1E24N SIEMENS [Siemens Semiconductor Group], SAB-C501G-1E24N Datasheet - Page 24

• Manufacturer Part Number: SAB-C501G-1E24N
• Description: 8-Bit CMOS Microcontroller
• Manufacturer: SIEMENS [Siemens Semiconductor Group]

Power Saving Modes
Two power down modes are available, the Idle Mode and Power Down Mode.
The bits PDE and IDLE of the register PCON select the Power Down mode or the Idle mode,
respectively. If the Power Down mode and the Idle mode are set at the same time, the Power Down
mode takes precedence. Table 10 gives a general overview of the power saving modes.
Table 10
Power Saving Modes Overview
Mode
Idle mode
Power-Down
Mode
In the Power Down mode of operation,
be ensured, however, that
is restored to its normal operating level, before the Power Down mode is terminated. The reset
signal that terminates the Power Down mode also restarts the oscillator. The reset should not be
activated before
to allow the oscillator to restart and stabilize (similar to power-on reset).
Semiconductor Group
V
CC
Entering
Instruction
Example
ORL PCON, #01H
ORL PCON, #02H
is restored to its normal operating level and must be held active long enough
V
CC
is not reduced before the Power Down mode is invoked, and that
V
CC
can be reduced to minimize power consumption. It must
Leaving by
– enabled interrupt
– Hardware Reset
Hardware Reset
24
Remarks
CPU is gated off
CPU status registers maintain
their data.
Peripherals are active
Oscillator is stopped, contents
of on-chip RAM and SFR’s are
maintained (leaving Power
Down Mode means redefinition
of SFR contents).
1997-04-01
C501
V
CC